TASCAM IF-FW/DM Downloads v. 2.10 Release Notes

TASCAM DM-24 Version 2.1 Release Notes

1

New features in DM-24 version 2.1

Buss assignment

Busses 1-8 can now be assigned to the stereo buss on

the

ASSIGN

page, the

MODULE

page and also using the

ASSIGN

section key.

Bear in mind that like

EFFECT 1-2

,

DIGITAL IN 1-2

and

ASSN RETURNS 1-4

, these signals enter the stereo buss

after (post) the Master Comp Insert Matrix.

The result of this is that if you are compressing the

stereo buss, these signals assigned to the stereo buss

are not affected by the compressor.

However, if the

ASSIGNABLE

sends and returns are

used as stereo buss

INSERTS

, these inserts will affect

the signals sent to the stereo buss. Any analog inserts

used on the stereo buss will also affect these signals.

1

To assign these signals directly to the stereo

buss, use POD 4 to move the cursor to

ST

in

the upper right of the

ASSIGN

page.

2

Then use the

SEL

key of the buss, or the cur-

sor keys or the dial to highlight the item you

wish to assign and press the

ENTER

key.

This assignment can also be made in the buss

MODULE

page.

To assign busses 1-8 to the stereo buss using the

STEREO

key in assign section:

1

Select the busses 1-8 using the

SEL

keys.

2

Then press the

STEREO

key in the assign sec-

tion. Busses 1-8 are assigned to the stereo

buss directly (this can be confirmed on the

MODULE

page).

Buss signals assigned to the stereo buss fol-

low the

Balance Level CENTER: 0dB

setting on the

OPTION-PREFERENCES

page.

9101449300

Section	Page
Buss assignment	1
Talkback source	2
ADAT S/MUX support	2
New default clock setting	2
Busses as effect input sources	3
New features in HUI	3

TASCAM IF-FW/DM Downloads v. 2.10 Release Notes

TASCAM IF-FW/DM Manual

TASCAM IF-FW/DM manual content summary: