TASCAM Model 16 Setting procedures for use with OBS Studio and other streaming

Setting procedures for use with OBS Studio and other streaming applications

Conduct the procedures in this document before launching the streaming application.

Model 16 unit settings

ATTENTION

The following content is supported by Model 16 firmware

V1.30 and later. If using a firmware version older than V1.30,

update it to use these features.

See the “FIRMWARE screen” section in “9 – Settings and

Information” of the Operation Manual for procedures about

how to check the firmware version.

1.

Set the MODEL 16 USB audio mode to STEREO MIX.

For setting procedures, see the following “USB audio mode”

section about this new feature.

2.

Turn the POST REC switch on to enable the MAIN fader for

streamed audio.

POST REC switch

o

For Macs, the above settings make use with streaming

applications possible.

Windows computer sound settings

Set the input and output device, sampling frequency, bit

rate, and number of channels according to the setup.

1.

Open the Sound Settings screen.

NOTE

This can also be opened by right-clicking the sound icon

at the bottom right of the desktop screen, selecting “Open

Sound settings” and then selecting “Sound”.

2.

Set the output device to “Speakers (Model 16)”.

3.

Set the input device to “Microphone (Model 16)”.

4.

Click “Sound Control Panel” to open the Sound window.

5.

Open the Recording tab, and select “Model 16”.

6.

Click “Properties” for “Model 16” to open the Microphone

Properties screen.

Model 16

TASCAM

Model 16

1

0620.MA-3148A