TASCAM Model 24 Setting procedures for use with OBS Studio and other streaming

Setting procedures for use with OBS Studio and other streaming applications

Conduct the procedures in this document before launching the streaming application.

Model 24 unit settings

ATTENTION

The following content is supported by Model 24 firmware

V1.60 and later. If using a firmware version older than V1.60,

update it to use these features.

See the “FIRMWARE screen” section in “9 – Settings and

Information” of the Operation Manual for procedures about

how to check the firmware version.

Set the MODEL 24 USB audio mode to STEREO MIX.

For setting procedures, see the following “USB audio mode”

section about this new feature.

NOTE

The MAIN fader does not affect streamed audio. To enable

use of a fader, turn on the MAIN switch (SUB) and use the SUB

bus fader.

o

For Macs, the above settings make use with streaming

applications possible.

Windows computer sound settings

Set the input and output device, sampling frequency, bit

rate, and number of channels according to the setup.

1.

Open the Sound Settings screen.

NOTE

This can also be opened by right-clicking the sound icon

at the bottom right of the desktop screen, selecting “Open

Sound settings” and then selecting “Sound”.

2.

Set the output device to “Speakers (Model 24)”.

3.

Set the input device to “Microphone (Model 24)”.

4.

Click “Sound Control Panel” to open the Sound window.

5.

Open the Recording tab, and select “Model 24”.

6.

Click “Properties” for “Model 24” to open the Microphone

Properties screen.

Model 24

TASCAM

Model 24

1

0620.MA-3150A