TASCAM US-1x2HR Specifications
TASCAM US-1x2HR Manual
 |
View all TASCAM US-1x2HR manuals
Add to My Manuals
Save this manual to your list of manuals |
TASCAM US-1x2HR manual content summary:
- TASCAM US-1x2HR | Specifications - Page 1
Product Spec Sheet USB Audio Interface US-1x2HR US-1x2HR Nov, 2020 ■ Specifications General Sampling frequencies 44.1, 48, 88.2, 96, 176.4, 192 kHz Quantization bit depth 24-bit Input/output ratings ・Analog inputs IN1 input - TASCAM US-1x2HR | Specifications - Page 2
US-1x2HR Maximum input level: Rated input level: Gain range: Input impedance: LINE 32 Ωload) ・Control input/output ratings USB Connector: Transfer rate: DC IN 5V Connector: 4-pin USB Type-C USB 2.0 High Speed (480 Mbps) USB Micro B type Audio performance Mic preamp EIN (equivalent input noise) - TASCAM US-1x2HR | Specifications - Page 3
US-1x2HR 0.0015% (LINE OUT, 1 kHz sine wave, −4 dBFS input, LINE OUT knob at maximum, 20 kHz SPCL LPF) Crosstalk 95 dB or more (MIC/LINE IN - TASCAM US-1x2HR | Specifications - Page 4
US-1x2HR ・Supported audio drivers Windows ASIO2.0, WDM Mac Core Audio iOS divice Core Audio Other Power Used with a computer USB bus power Used with an iOS device USB strongly recommend using TASCAM PS-P520E AC adapter or the USB power adapter included with the iPad/iPhone. No USB power adapter is
-
1 -
2 -
3 -
4
 |
 |
US-1x2HR
0108a
-
1-
Nov, 2020
Product Spec Sheet
USB Audio Interface
US-1x2HR
■
Specifications
General
Sampling frequencies
44.1, 48, 88.2, 96, 176.4, 192 kHz
Quantization bit depth
24-bit
Input/output ratings
・
Analog inputs
IN1 input
Mic input (Balanced)
Connector:
XLR-3-31 equivalent (1: GND, 2: HOT, 3: COLD)
Maximum input level:
+9 dBu (2.183 Vrms)
Rated input level:
−
7 dBu (0.346 Vrms)
Gain range:
56 dB
Input impedance:
2.4 kΩ
IN2 input
LINE input (Balanced)
(LINE/INST switch set to LINE)
Connector:
6.3
mm (1/4”
) standard TRS jack
(Tip: HOT, Ring: COLD, Sleeve: GND)
Maximum input level:
+20 dBu (7.750 Vrms)
Rated input level:
+4 dBu (1.228 Vrms)
Gain range:
45 dB
Input impedance:
10 kΩ
INST input (Unbalanced)
(LINE/INST switch set to INST)
Connectors:
6.3 m
m (1/4”) standard TS jacks
(Tip: HOT, Sleeve: GND)