TP-Link Auranet EAP110 EAP110 V1 Quick Install Guide

Quick Installation Guide

EAP110

7106505541 REV1.0.0

LED

Indication

Hardware Overview

2

Hardware Installation

3

Software Configuration

The EAP110 can be powered with the provided PoE adapter.

Power Supply

1

(Up to 100m)

Switch

3

PoE

LAN

PoE Adapter

2

1. Connect the ETHERNET port to the POE port of the PoE adapter using an Ethernet cable. The cable

length can be up to 100 meters.

2. Connect the Ethernet cable from the switch to the LAN port of the PoE adapter.

3. Plug the female connector of the provided power cord into the PoE adapter, and the male connector to a

power outlet.

RESET

ETHERNET

Interface Panel

Passive PoE Adapter

RESET

With the device powered on, press and hold the button for about 8 seconds until the LED flashes red, then

release the button. The device will restore to factory default settings.

ETHERNET

The port

is to connect to the POE port of the provided PoE adapter for both data transmission and power

supply through Ethernet cabling.

Power LED

The Power LED indicates the status of the electric current: green (0-0.8A), red (0.8A-1A).

PoE Port

This port is used to connect to the

ETHERNET port of EAP110.

LAN Port

This Port is used to connect to your LAN.

1

Network Topology Requirement

Clients

Switch

EAP

EAP

EAP

Controller Host

EAP Controller

Router

Internet

A DHCP server (typically a router) is required to assign IP addresses to the EAP and clients in your local network.

A computer running the EAP Controller software, which can be in the same or different subnet with the EAPs.

Option 1: Ceiling Rail Mounting

Option 2: Ceiling Mounting

Option 3:

Wall Mounting

The EAP can be ceiling rail mounted, ceiling-mounted, and wall-mounted.

The instructions for various mounting options are on the back of this Quick Installation Guide.

The device is working properly.

Solid green

System errors. RAM, Flash,

Ethernet, WLAN or firmware

may be malfunctioning.

Flashing red

The device is being reset to its

factory default settings.

Double-flashing red, green, yellow

Firmware update is in progress.

Do not disconnect or power off

the device.

Flashing yellow

Power LED

7106505541 REV1.0.0

To quickly set up a wireless network connection with mass EAPs, please follow the steps below.

For More Configurations

Now you can manage your wireless network and view network statistic using the EAP Controller. Please refer

to the EAP Controller User Guide to learn more information on configuring and using the Controller software.

Find the EAP Controller application file on the Resource CD (for Windows user only) or from our website at

www.tp-link.com. Run the file and follow the wizard to install the EAP Controller on the computer.

Step 1: Installing the EAP Controller

Launch the EAP Controller and follow the configuration wizard to create a primary wireless network. After the wizard

is finished, a login screen will appear. Enter the admin name and password you created and click Sign In.

Step 2: Configuring the EAP Controller

Adopt the EAP devices in the Controller management interface to change the status from pending to connected.

Step 3: Adopting the EAP devices

Note:

The IP address of the management computer must be reachable for the EAPs in the network.