Thermador PODM301J SP

Lens

10W

Halogen

Lamp

Fixing

Clip

Housing

Ceramic

Holder

Holder

Clip

1.

Turn off circuit breaker.

2.

Remove oven racks.

3.

Slide the tip of a flat blade screw

driver between the fixing clip and

the lamp housing.

4.

Support the glass lens cover with two

fingers along the bottom edge to

prevent the cover from falling to the

bottom of the oven.

5.

Gently twist the flat blade screw driver

to loosen the glass lens cover.

6.

Remove the glass lens cover and

fixing clip.

7.

Remove the bulb by grasping and

sliding the bulb straight up until the two

prongs have cleared the ceramic holder.

8.

Do not touch the glass of the

new

replacement bulb with

your fingers. It

will cause the bulb to fail when it first

lights.

Grasp the replacement bulb with

a clean paper towel or facial tissue with

the prongs facing down.

Locate the two

prongs in the ceramic holder, gently

poking until the two prongs locate in the

ceramic socket.

9.

Press down to seat the bulb.

10.

Slide the protective lens into the

holder clip and push the other

end until the fixing clip snaps back

into the housing.

11.

Turn on circuit breaker.

Important:

Alternate Halogen Bulb Replacement Instructions

To replace the halogen bulb on the oven sidewall:

Loosen glass

lens cover and

remove

9000407452

5V0E02

Slide screw

driver tip here

Thermador PODM301J SP

Thermador PODM301J Manual

Thermador PODM301J manual content summary: