Uniden EXS9005 English Owners Manual

Uniden EXS9005 Manual

Get Uniden EXS9005 PDF manuals and user guides View all Uniden EXS9005 manuals
Add to My Manuals
Save this manual to your list of manuals

Uniden EXS9005 manual content summary:

  • Uniden EXS9005 | English Owners Manual - Page 1
  • Uniden EXS9005 | English Owners Manual - Page 2
    equipment in any charger other than the one designed to charge this battery as specified in this Guide. Using another charger may damage the battery or cause the battery to explode. Rechargeable Nickel-Cadmium Batteries Must Be Recycled or Disposed of Properly s Residents of Minnesota should contact
  • Uniden EXS9005 | English Owners Manual - Page 3
    Controls and Keys 1. Talk/Batt Low Indicator - talk • batt low 2. Talk Key - talk 3. Numeric Keypad 4. Memory Key - mem 5. Microphone 6. Redial Key - redial 7. Flash Key - flash 8. Pause Key - pause 9. Volume Up (volume v) 10. Volume Down (volume w) 11. Page/Find Key - page/find 12. Charge LED
  • Uniden EXS9005 | English Owners Manual - Page 4
    Instructions 2 Introduction 4 Features 4 Included with the EXS9005 5 Important Electrical Considerations 6 Range 6 Telephone Line Problems 6 Radio Interference 7 More Than One Cordless Telephone 7 Installation 8 Selecting a Location 8 Telephone Line Outlets 8 Connecting the Telephone
  • Uniden EXS9005 | English Owners Manual - Page 5
    Instructions When using your telephone equipment, these basic safety precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons: 1. Read and understand all instructions. 2. Follow all warnings and instructions The telephone service personnel when service
  • Uniden EXS9005 | English Owners Manual - Page 6
    use the telephone to report a gas leak in the vicinity of the leak. Battery Safety Precautions Caution: To reduce the risk of fire or injury to persons by the battery, read and follow these instructions: 1. Use only the appropriate type and size Battery Pack specified in this Operating Guide. 2. Do
  • Uniden EXS9005 | English Owners Manual - Page 7
    Congratulations on your purchase of the Uniden EXS9005 Cordless Telephone. This phone is designed to exacting standards that AutoSecure™ · Pulse/Tone Dialing · AutoStandby™ · 1-way Page/Find Button · 7 Day Battery Life AutoTalk™ allows you to answer a call by just removing the Handset from the Base
  • Uniden EXS9005 | English Owners Manual - Page 8
    EXS9005 Other Printed Material 5 Operating Guide UDZZ01838ZZ A`e9wtah`wthgÌcA`wgaee9`hwttadh` Battery Long Telephone Cord Short Telephone Cord Included with the EXS9005 Handset Base Unit AC Adapter Included with the EXS9005 If any of these items are missing or damaged, contact Uniden
  • Uniden EXS9005 | English Owners Manual - Page 9
    to such actions to allow you time for making necessary arrangements to continue uninterrupted service. If you are having trouble with your telephone service, you must first disconnect your phone to determine if it is the cause of your problem. If you determine that it is the cause, you must leave it
  • Uniden EXS9005 | English Owners Manual - Page 10
    may be causing the problem. In addition, we recommend Cordless Telephone Don't operate two cordless phones too close to each other because of the interference. This interference can be reduced by lowering your base unit antenna (reducing its range). Privacy Note: Cordless telephones are radio
  • Uniden EXS9005 | English Owners Manual - Page 11
    Hard-wired Jack Some equipment is wired directly to a phone jack, and these types of installations require a modular jack converter. This type of installation is not difficult; however, you should contact your Uniden telephone dealer or a telephone supply store for advice about the proper adapter or
  • Uniden EXS9005 | English Owners Manual - Page 12
    chafed and create a fire or other electrical hazards. Adapter Safety Feature The AC adapter furnished with this phone may be equipped with a polarized line plug - a plug having one blade wider than the other. This into the outlet, contact someone about replacing the outlet. Installation EXS9005 9
  • Uniden EXS9005 | English Owners Manual - Page 13
    into the 9 VDC input jack on the Base Unit. 2. Place the AC Adapter cord around the strain relief notch. 3. Plug one end of the long telephone cord into the TEL LINE jack on the Base Unit. 4. Plug the other end of the cord into the
  • Uniden EXS9005 | English Owners Manual - Page 14
    5. Plug the AC Adapter into a standard 120 VAC wall outlet. Do not use an outlet controlled by a wall switch. Use only the Uniden AC Adapter supplied with this phone. 6. Place the Base Unit on a desk or tabletop. In desk or table top installation, the Handset is designed to stand only vertically in
  • Uniden EXS9005 | English Owners Manual - Page 15
    Wall Installation Standard Wall Plate Mounting These phones are designed to be mounted on a standard AT&T or GTE wall plate. To attach the wall mount to the Base Unit: 1. Slide Base Unit. 2. Rotate the wall mount stand down and snap into place. 3. Plug the AC Adapter into the Base Unit. 12 EXS9005
  • Uniden EXS9005 | English Owners Manual - Page 16
    5. Plug one end of the short telephone cord into the TEL LINE jack on the Base Unit. Place the telephone cord inside the molded channel on the bottom of the Base Unit. Then plug the other end of the telephone cord into the modular
  • Uniden EXS9005 | English Owners Manual - Page 17
    a wall. Before mounting your phone, consider the following: · Select a location away from electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall. · Make sure the wall material is capable of supporting the weight of the Base
  • Uniden EXS9005 | English Owners Manual - Page 18
    3. Rotate the wall mount stand down and snap into place. 4. Plug the AC Adapter into the Base Unit. 5. Wrap the AC Adapter cord around the strain relief notch. Then put the AC Adapter cord inside the molded channel. EXS9005 15 Installation
  • Uniden EXS9005 | English Owners Manual - Page 19
    bottom of the Base Unit. 7. Place the Base Unit on the screws and push down until it's firmly seated. 8. Plug the other end of the telephone line cord into the wall jack. 9. Plug the AC Adapter into a standard 120 VAC wall outlet. T Do not use an outlet controlled by a wall switch
  • Uniden EXS9005 | English Owners Manual - Page 20
    Setting Up Your Phone Setting Up Your Phone Raising the Antenna Before using your phone, be sure to raise its antenna to the vertical position. Installing the Handset Battery Pack 1. Press in on the Battery Cover Release and slide the battery compartment cover down. 2. Align the plastic connector
  • Uniden EXS9005 | English Owners Manual - Page 21
    the Handset on the Base Unit. T In desk or table top use, the Battery charges only in the vertical position. -or- Hang the Handset on the cradle when the phone is mounted on a wall. 2. Make sure the status LED lights. If the LED doesn't light, check to see that the AC adapter
  • Uniden EXS9005 | English Owners Manual - Page 22
    Setting Up Your Phone Battery Memory Effect Rechargeable batteries can develop a reduced charge capacity caused by repeated charge and discharge cycles. Rechargeable batteries that have developed this effect will not operate to their fullest capacity. To avoid memory effect, operate the unit until
  • Uniden EXS9005 | English Owners Manual - Page 23
    Cleaning the Battery Contacts To maintain a good charge, it is important to clean all charging contacts sure the PULSE/TONE switch is in the TONE position. T Most phone systems are Tone dialing. Check with your local phone company if you are not sure whether your system is Tone or Pulse dialing 20
  • Uniden EXS9005 | English Owners Manual - Page 24
    phone is not in use, press flash and then either 1, 2, 3, or 4 on the keypad. The ringer tone sounds. To change the ringer tone volume: While the phone is not in use, press either volume v(up) or w(down). Receiver volume While you are on a call, press either volume v(up) or w(down). The phone
  • Uniden EXS9005 | English Owners Manual - Page 25
    Changing the Beltclip Attach the beltclip 1. Remove the slot cover. 2. Put the beltclip in the slot and press down until it clicks. Remove the Beltclip 1. Pull back on the release tab and pull up. 2. Replace the slot cover. 22 EXS9005
  • Uniden EXS9005 | English Owners Manual - Page 26
    Making and Receiving Calls The following features of the EXS9005 phones are different depending on the Handset's location when you Handset close to the Base Unit. Flash and Page/Find To access call waiting while the phone is in use or to use the one-way page to locate the Handset, follow these
  • Uniden EXS9005 | English Owners Manual - Page 27
    because programming keys do not function while you are on the phone. Storing a Number in Memory Use these keys to store a digits). 5551212 4. If a pause is needed during dialing to access a long distance service, press pause. 9 pause 5551212 j The pause button counts as one digit. Pressing pause
  • Uniden EXS9005 | English Owners Manual - Page 28
    a invalid two-digit memory location, a loud single beep sounds. Storing a Mixed Number If your phone is set up for Pulse dialing, you can store a mixed mode number so that you can easily access long distance services. Use these keys to store a mixed mode number in memory. T An error tone will sound
  • Uniden EXS9005 | English Owners Manual - Page 29
    be dialed in tone mode. 3300 6. If a pause is needed during dialing to access a long distance service, press pause. P 3300 j The pause button counts as one digit. Pressing pause more than once increases . If you enter a invalid two-digit memory location, a loud single beep sounds. 26 EXS9005
  • Uniden EXS9005 | English Owners Manual - Page 30
    To dial a number previously stored in memory, follow these steps: 1. Remove the Handset from the Base Unit. 2. Press talk. 3. Press mem. Programming Your Phone 4. Press the two-digit memory location number (01-20). Example: for memory location 02, you would press 0, then 2. If you enter a invalid
  • Uniden EXS9005 | English Owners Manual - Page 31
    Chain Dialing On certain occasions, after dialing a number, you may be requested by the party or service you are calling to enter a special access code, such as when performing a banking transaction. To do entry or step, an error tone will sound and the erase procedure will be canceled. 28 EXS9005
  • Uniden EXS9005 | English Owners Manual - Page 32
    Troubleshooting If your Cordless Telephone is not performing to your expectations, please try these simple steps. If you are still unable to resolve the problems, contact Uniden Customer Service at (800) 297-1023, 8:00 a.m. to 5:00 p.m. Central, Monday through Friday. Problem Suggestion Charge
  • Uniden EXS9005 | English Owners Manual - Page 33
    Ni-Cd Battery Pack 2 in. (W) x 2-1/4 in. (D) x 7-1/2 in. (H) Approx. 9 oz. (including battery) BT-905 Capacity Talk Mode Standby Mode 600 mAH, 3.6V 4 hours 7 days Specifications, Features, and availability of Optional Accessories are all subject to change without prior notice. 30 EXS9005
  • Uniden EXS9005 | English Owners Manual - Page 34
    than an authorized Uniden service center for a defect or malfunction covered by this warranty, (E) used in any conjunction with equipment or parts or as part of any system not manufactured by Uniden, or (F) installed or programmed by anyone other than as detailed by the Operating Guide for this
  • Uniden EXS9005 | English Owners Manual - Page 35
    Covered under one or more of the following U.S. patents: 4,511,761 4,523,058 4,595,795 4,797,916 5,426,690 ©1997 Uniden America Corporation. Printed in China. All rights reserved.
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35