Uniden GMR1235-2 English Owners Manual

GMR1235-2

*Range may vary depending on environmental and/or topographical conditions.

•

15 GMRS / 7 FRS Channels

•

Long Battery Life

•

Up to 12-mile Range*

•

Channel Scan

•

Channel Monitor

•

Battery Strength Meter

•

Call Button

•

Roger Beep

•

Keytone on/off

1

Antenna

2

PTT (Push-To-Talk) Button

3

Channel/Scan up Key

4

Call/lock Key

5

Channel/Scan down Key

6

Speaker

7

Volume up/Monitor Key

8

Power On/Off Key

9

Volume down/Monitor Key

10

Microphone

11

Channel Indicator

12

Receive Indicator

13

Battery Level Indicator

14

Transmit Indicator

Congratulations on your purchase of the

Uniden GMR1235-2 (General Mobile Radio

Service) radio. This lightweight, palm-sized,

radio is a state-of-the-art device, equipped

with many valuable features. Use it at sporting

events, to stay in contact with family and

friends, hiking, skiing, outdoors, or in a

neighborhood watch for vital communication.

PACKAGE CONTENTS

Your package contains the 2 GMR1235 radios,

6 AAA alkaline batteries, this reference guide

and 2 belt clips.

FCC GMRS LICENSE

The GMR1235-2 radio operates on the

General Mobile Radio Service (GMRS)

frequencies which require a Federal

Communications Commission license to

operate. For licensing information and

application forms, visit the FCC on-line

at:www.fcc.gov/wtb/uls or call the FCC

hotline at 1-800-418-3676. If you have any

questions you can contact the FCC direct at

1-888-225-5322.

INSTALL THE BATTERIES

Your GMR1235-2 radio uses 3 AAA alkaline

batteries for power. We recommend using high

quality alkaline batteries.

To install the batteries:

1) Make sure your radio is OFF.

2) Remove the battery compartment door by

pressing on and sliding the compartment

door, and remove the cover.

3) Install 3 AAA Alkaline batteries into the

battery compartment. Be certain to follow

the + and

–

symbols in the compartment.

Installing the batteries incorrectly will

prevent the unit from operating.

4) Replace the battery compartment door by

sliding the door into place.

USING THE RADIO

In order to get the most out of your new radio, read

this reference guide completely before attempting to

operate the radio.

Turning the Radio On and Adjusting the Volume

1) Press and hold the

key to turn the radio ON.

2) To change the volume level press the

vol/mon

▲

or

▼

key to increase or decrease the volume

level.


key to turn the radio OFF.

Adjusting the Sound (Key Beeps)

Your radio emits a beep each time one of the keys

(except for the

PTT

button and

call/lock

key) is

pressed. The sound of the Key Beep will increase or

decrease depending on the volume level setting.

To turn OFF this beep:

Press and hold the

call/lock

key while turning ON

the radio.

To turn ON this beep:

Turn the radio OFF and ON again without pressing

the

call/lock

key.

Choosing a Channel

Your GMR1235-2 radio has 22 channels you can

use to talk to others. In order to speak to someone,

each of you must be set to the same channel.

To choose a channel:

Press the

ch/scan

▲

or

▼

key to increase or

decrease the channel number displayed.

Channel Scan Feature

Your GMR1235-2 radio has a channel scan feature

that allows you to easily scan all 22 channels. When

an active channel is detected, the unit pauses on

that channel until the channel is clear. Then after a 2

second delay, the radio continues scanning.

Pressing

PTT

button while the scan is paused on a

channel will allow you to transmit on that channel.

To turn ON channel scan:

Press and hold either the

ch/scan

▲

or

▼

key for

3 seconds. The channel number on the display will

rapidly cycle through the channels.

To turn OFF channel scanning:

Press either the

ch/scan

▲

or

▼

key.

Talking on Your Radio

To talk to others using the radio:


PTT

button and speak in a

clear, normal voice about 2-3 inches away from

the microphone.

While you are transmitting, the

tx

icon is

displayed.To avoid cutting off the first part of

your transmission, pause slightly after pressing

the

PTT

button before you start talking.

2) When you are finished speaking, release the

PTT

button.You can now receive incoming calls.

While receiving, the

rx

icon is displayed.

Transmitting a Call Alert Tone

Your GMR1235-2 radio is equipped with a call tone

that will be transmitted when the

call/lock

key is

pressed.

To transmit the call tone, tap the

call/lock

key. The

tone will be transmitted.

Auto Squelch Feature

The GMR1235-2 is equipped with an automatic

squelch system which shuts off weak transmissions

and unwanted noise due to terrain conditions or if

you have reached your range limit.

Monitor Mode Feature

Your GMR1235-2 radio allows you to listen for weak

signals on the current channel at the press of a key.

To turn ON monitor mode:

Press and hold the

vol/mon

▲

or

▼

key.

The

rx

icon will blink.

To turn OFF monitor mode:

Press the

vol/mon

▲

or

▼

key. The

rx

icon will

stop blinking and disappears.

Automatic Power Save Feature

Your GMR1235-2 has a unique circuit designed to

dramatically extend the life of the batteries. If there is

neither a transmission nor an incoming call within 2

seconds, your radio switches to the Power Save mode.

The radio is still able to receive transmissions in this

mode.

KEYLOCK ON/OFF

Press and hold the

call/lock

key until the "L"

appears. After 1 second, the LCD will return to the

channel display.

To exit Keylock on mode, press and hold

call/lock

again.

Note:

While in keylock on mode, it will still receive

transmissions.

SPECIFICATIONS

Channels

15 GMRS / 7 FRS

Operating Frequency

UHF 462.5500-

467.7125 MHz

Power Source

3 AAA Alkaline Batteries

Battery Life

20 Hours typical

(5/5/90 duty cycle)

Frequency Chart

Ch.

Freq.

[MHz]

Cross Ref.

Ch.

Freq.

[MHz]

Cross Ref.

1

462.5625

FRS & GMRS 1

12

467.6625

FRS 12

2

462.5875

FRS & GMRS 2

13

467.6875

FRS 13

3

462.6125

FRS & GMRS 3

14

467.7125

FRS 14

4

462.6375

FRS & GMRS 4

15

462.5500

GMRS 11

5

462.6625

FRS & GMRS 5

16

462.5750

GMRS 8

6

462.6875

FRS & GMRS 6

17

462.6000

GMRS 12

7

462.7125

FRS & GMRS 7

18

462.6250

GMRS 9

8

467.5625

FRS 8

19

462.6500

GMRS 13

9

467.5875

FRS 9

20

462.6750

GMRS 10

10

467.6125

FRS 10

21

462.7000

GMRS 14

11

467.6375

FRS 11

22

462.7250

GMRS 15

ROGER BEEP

Roger Beep is a BEEP that is sent automatically at

the end of transmissions.

Roger Beep can be heard through the speaker

when both Roger beep and Key Beep are set to

ON. When Roger beep is set to ON and Key Beep

OFF, Roger Beep will not be heard from the

speaker but it will be transmitted to your party.

When Roger Beep is set to OFF, Roger Beep

neither be heard nor transmitted.

To turn OFF Roger Beep:

Press and hold the

ch/scan

▲

key while turning

ON the radio.

To turn ON Roger Beep:

Turn the radio OFF and ON again without pressing

ch/scan

▲

key.

Note:

If you press either the

ch/scan

▲

or

▼

key while the unit is pausing on a

channel, scanning will resume.

Uniden GMR1235-2 English Owners Manual

Uniden GMR1235-2 Manual

Uniden GMR1235-2 manual content summary: