Vaddio ProductionVIEW HD-SDI MV External Control Systems w/TeleTouch FAQs

Vaddio • 131 Cheshire Lane Minnetonka,MN 55305 • 800-572-2011 • 763-971-4400 • FAX: 763-971-4464 • vaddio.com

TechNote 207

External Control Systems with TeleTouch Monitor

It is possible to connect both a TeleTouch monitor and an external control system to our MultiViewer Controllers.

The TeleTouch monitor is only a transmit device. Below is an example of the connectivity.

All information from the TeleTouch would be received from the control system and immediately sent out the com

port to the MultiViewer controller.

All control codes from the control system would also be sent out the com port to the MultiViewer controller.

The TeleTouch and control system SHOULD NOT BE USED SIMULTANEOUSLY.

Response from the TeleTouch may be slightly delayed depending on the throughput delays caused by the control

system. However reports indicate that it is barely perceptible when using Crestron or AMX.

2

RX

3T

X

5

GND

2R

X

3T

X

5

GND

2R

X

3T

X

5GND

2R

X

3TX

5GND