Vaddio Vaddio ClearVIEW HD-19 ClearVIEW HD-19 Camera Firmware Update Instructi
Vaddio Vaddio ClearVIEW HD-19 Manual
View all Vaddio Vaddio ClearVIEW HD-19 manuals
Add to My Manuals
Save this manual to your list of manuals |
Vaddio Vaddio ClearVIEW HD-19 manual content summary:
- Vaddio Vaddio ClearVIEW HD-19 | ClearVIEW HD-19 Camera Firmware Update Instructi - Page 1
/Control and Video. Please refer to the appropriate section in these instructions for the file you will be updating. Requirements: - RS232 adapter connector - Latest version of Vaddio Loader program from Vaddio Support website http://support.vaddio.com/resources#cat_3 (Scroll down to Vaddio Loader at - Vaddio Vaddio ClearVIEW HD-19 | ClearVIEW HD-19 Camera Firmware Update Instructi - Page 2
For HD-19 Camera/Control update: • Note dip switch and rotary switch settings on camera prior to upgrade. Rotate HD Video Select rotary switch to "A" setting and place Camera Settings dip sw 3 up and 10 down and reboot camera. Camera is now in bootloader mode and red tally light will be on in front - Vaddio Vaddio ClearVIEW HD-19 | ClearVIEW HD-19 Camera Firmware Update Instructi - Page 3
For HD-19 Video update: • Note dip switch and rotary switch settings on camera prior to upgrade. • Power camera with normal settings and with power still on, set dip 10 to the down position and turn rotary dial to "C" position. • Connect a cat5 cable from the upper RS232 port to the RJ-45 end of the - Vaddio Vaddio ClearVIEW HD-19 | ClearVIEW HD-19 Camera Firmware Update Instructi - Page 4
For HD-19 Motor update: • Note dip switch and rotary switch settings on camera prior to upgrade. Rotate HD Video Select rotary switch to "B" setting and place Camera Settings dip sw 3 up and 10 down and reboot camera. Camera is now in bootloader mode and red tally light will be on in front of camera - Vaddio Vaddio ClearVIEW HD-19 | ClearVIEW HD-19 Camera Firmware Update Instructi - Page 5
Troubleshooting: If HEX on website opens instead of downloading, right click on file below. This is a USB camera response from the lower rs232 port. If you have any questions call Tech Support at Vaddio. 763.971.4400. If the update procedure is interrupted for any reason the product may need to
Vaddio HD-19 Camera Firmware Update Instructions
NOTE: There are three separate files for camera operation. They are labeled Motor,
Camera/Control and Video.
Please refer to the appropriate section in these instructions for the file you will be
updating.
Requirements:
- RS232 adapter (Vaddio part# 998-1001-232)
- PC with serial connection or USB to Serial connector
- Latest version of Vaddio Loader program from
Vaddio Support
website
(Scroll down to Vaddio Loader at bottom of page)
- Ethernet cable
- Camera software
1: Download and save software here:
(Scroll down to
Software Updates – choose appropriate software file for the update needed)
2: Download and install latest Vaddio loader software
here
:
-
(Scroll down to Vaddio Loader at bottom of page) NOTE: If you have a previous version of Vaddio Loader
installed, go to Control Panel and un-install previous version.
3: Make sure you know which PC com port is used with your serial connection and open Vaddio Loader.
Select the proper com port if prompted.