Viking RDSCD2305BSS Installation Instructions
Viking RDSCD2305BSS Manual
 |
View all Viking RDSCD2305BSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Viking RDSCD2305BSS manual content summary:
- Viking RDSCD2305BSS | Installation Instructions - Page 1
Installation Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Website at vikingrange.com F20938 EN (032012) Freestanding 30" Dual Fuel Self-Clean Sealed Burner Range - Viking RDSCD2305BSS | Installation Instructions - Page 2
25 Service & Registration 26 2 IMPORTANT-Read and Follow! • Before beginning, please read these instructions completely and of others is very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is - Viking RDSCD2305BSS | Installation Instructions - Page 3
moisture. • Viking Range Corporation will NOT warranty any problems resulting from IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, instructions. -If you cannot reach your gas supplier, call the fire department. • Installation and service must be performed by a qualified installer, service - Viking RDSCD2305BSS | Installation Instructions - Page 4
1/2" (1.3 cm) ID gas service line Gas Manifold Pressure Natural Cord must be agency approved for use with household electric ranges. Max Amp Usage Surface Burner Rating Natural/LP Left front [91.4 cm] and below) • Sides - 0" • Top grate support - 36" (91.4 cm) Above cooking surface (above 36" [91 - Viking RDSCD2305BSS | Installation Instructions - Page 5
typically result in the bottom of the hood being 66" (167.6 cm) to 72" (182.9 cm) above the floor. Refer to the range hood installation instructions for additional information. These dimensions provide for safe and efficient operation of the hood. Note: Minimum clearance for back wall is 0" with - Viking RDSCD2305BSS | Installation Instructions - Page 6
be resistive to LP gas. The range is designed specifically for natural gas. Before beginning installation verify that the model is compatible with the intended gas supply. Manual shut-off valve: This installer-supplied valve must be installed in the gas service line before the appliance in the gas - Viking RDSCD2305BSS | Installation Instructions - Page 7
or excessive noise coming from the cooling fan, contact a Viking Authorized Service Center before continuing operation. Failure to do so can result . Door Removal 1 Backguard Installation 1 1 x4 2 Attach backguard to range with screws provided. 2 Open door completely. Place pins, supplied with - Viking RDSCD2305BSS | Installation Instructions - Page 8
a 4-wire connection, see following section for 4-wire connection instructions. WARNING Electrical shock hazard. To avoid risk or electrical shock 125/250 volts with closed loop terminals and marked for use with ranges. Where local codes do not permit grounding through neutral, use a 4-wire power - Viking RDSCD2305BSS | Installation Instructions - Page 9
- 125/250 volts with closed loop terminals and marked for use with ranges. Where local codes do not permit grounding through neutral, use a 4-wire power supply the terminal block, which is located behind the access door on the back of the range. 1 2 1 Remove access door. 2 3 3 1 2 Remove supply cord - Viking RDSCD2305BSS | Installation Instructions - Page 10
block. To connect eyelet style wires, use holes on right side of terminal. 5 Feed supply cord up through hole in bottom of range back. 6 1 2 Attach ground lead (green) with ground screw that was removed. 7 1 1 2 Attach line #1 (red) and line #2 (black) leads to outside terminal. Attach - Viking RDSCD2305BSS | Installation Instructions - Page 11
rear wall with the top left corner at measurement (A) plus 1/2" (1.3 cm) from the floor and 3-5/8" (9.2 cm) from where the right side of range (facing range) is to be located. 4 Mark and drill holes where bracket will be located. Attach bracket with mounting hardware provided. Floor Mount Anti-tip - Viking RDSCD2305BSS | Installation Instructions - Page 12
testing of the appliance must be conducted according to the manufacturer's instructions. Before placing appliance in operation, always check for gas leaks with dealer, a qualified licensed plumber, or gas service company. 22 Final Installation 1 2 Slide range into place. Be sure anti-tip bracket - Viking RDSCD2305BSS | Installation Instructions - Page 13
Door Replacement and Adjustment 1 2 Reattach door to range. 3 2 1 2 3 Open door completely. Reattach hinge trim on both sides. 4 Remove pins from holes in hinges. 5 Close door. If the door needs to be adjusted, loosen - Viking RDSCD2305BSS | Installation Instructions - Page 14
used in performing service on the appliance. All servicing should be referred to a qualified technician. Contact Viking Range Corporation, 1-888-VIKING1 (845-4641), for the nearest service parts distributor in your area or write to: VIKING RANGE CORPORATION PREFERRED SERVICE 1803 Hwy 82W Greenwood
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
 |
 |
Viking Range Corporation
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
For product information, call 1-888-VIKING1 (845-4641)
or visit the Viking Website at vikingrange.com
F20938 EN
(032012)
Freestanding 30” Dual Fuel
Self-Clean Sealed Burner Range
Installation