Viking RVDR3302 Installation Instructions

Viking RVDR3302 Manual

Viking RVDR3302 manual content summary:

  • Viking RVDR3302 | Installation Instructions - Page 1
    Installation 3 Series Freestanding 30" Dual Fuel Self-Clean Sealed Burner Range RVDR3302 / CRVDR3302
  • Viking RVDR3302 | Installation Instructions - Page 2
    Table of Contents Warnings & Important Safety Instructions 3 Dimensions 6 Specifications 7 Clearance Dimensions (Proximity to Cabinets 8 Clearance Dimensions (Wood/Composite Overlay Installation 23 Door Replacement 24 Final Preparation 25 Performance Checklist 25 Service & Registration 26 2
  • Viking RVDR3302 | Installation Instructions - Page 3
    Z223.1/NFPA-54 - latest edition. • The installer must leave these instructions with the consumer who should retain for local inspector's use and for is very important. We have provided many important safety messages in this manual and on your appliance. ALWAYS read and obey all safety messages. This
  • Viking RVDR3302 | Installation Instructions - Page 4
    or moisture. • Viking Range, LLC will NOT warranty any problems resulting from GFI IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, instructions. -If you cannot reach your gas supplier, call the fire department. • Installation and service must be performed by a qualified installer, service
  • Viking RVDR3302 | Installation Instructions - Page 5
    . DANGER GAS LEAK HAZARD To avoid risk of personal injury or death; leak testing of the appliance must be conducted according to the manufacturer's instructions. Before placing appliance in operation, always check for gas leaks with soapy water solution. • DO NOT USE AN OPEN FLAME TO CHECK FOR GAS
  • Viking RVDR3302 | Installation Instructions - Page 6
    Dimensions RVDR3302/CRVDR3302 (2795-.97/c8m") ((99413..0153c-ct7m7mo/"))8mm"ainx.. 6" (15.2 cm) 27-1/8" (68.9 cm) 25" (63.5 cm) 29" (73.7 cm) 25" (63.5 cm) 35-7/8" (91.1
  • Viking RVDR3302 | Installation Instructions - Page 7
    Specifications RVDR3302/CRVDR3302 Description Overall width 29-7/8" (75 standard residential 1/2" (1.3 cm) ID gas service line Natural 5.0" W.C.P./ Liquid Propane L/P 10 surface (36" [91.4 cm] and below) • Sides - 0" • Top grate support - 36" (91.4 cm) Above cooking surface (above 36" [91.4 cm])
  • Viking RVDR3302 | Installation Instructions - Page 8
    Clearance Dimensions (Proximity to Cabinets) • This range may be installed directly adjacent to existing 36" (91.4 cm) high base cabinets. IMPORTANT: The side trim MUST be 3/8" (.95 cm) above the adjacent base cabinet countertop. This can be accomplished by raising the unit using the adjustment
  • Viking RVDR3302 | Installation Instructions - Page 9
    of the hood being 66" (167.6 cm) to 72" (182.9 cm) above the floor. Refer to the range hood installation instructions for additional information. These dimensions provide for safe and efficient operation of the hood. WoodO/Cveormlapyosite ((7611268672""t..mmo69 accinmmx..)) WoodO/Cveormlapyosite
  • Viking RVDR3302 | Installation Instructions - Page 10
    240-208 VAC/60 Hz. See "Electrical Connection" section for grounding instructions. Must be fused seperately from any other circuit. WARNING ELECTRICAL SHOCK a qualified licensed plumber or gas service company. Please provide the service person with this manual before work begins. Pressure Regulator:
  • Viking RVDR3302 | Installation Instructions - Page 11
    Electrical & Gas Requirements Flexible Connections: If the unit is to be installed with flexible couplings and/or quick-disconnect fittings, the installer must use a heavy-duty AGA design-certified flexible connector of at least 1/2" (1.3 cm) ID NPT (with suitable strain reliefs) in compliance with
  • Viking RVDR3302 | Installation Instructions - Page 12
    . If you notice the cooling fan is not operating or you observe unusual or excessive noise coming from the cooling fan, contact a Viking Authorized Service Center before continuing operation. Failure to do so can result in damage to the oven or surrounding cabinets. Moving, Handling, and Unpacking
  • Viking RVDR3302 | Installation Instructions - Page 13
    Installation NOTICE DO NOT use the handle or oven door to lift the oven. Remove door before installation to ensure that it is not used to lift the unit. DO NOT lift or carry the door by the handle. Removing the door must be done by your dealer, a qualified licensed plumber, or certified gas
  • Viking RVDR3302 | Installation Instructions - Page 14
    Leg Installation 1 2 Legs are packed in the cardboard top pack. Note: Legs should be installed near to where appliance is to be used, as they are not secure for long transit. 3 1 1 3 2 Note: It is strongly recommended that a pallet or lift jack be used rather than tilting. Raise unit about a
  • Viking RVDR3302 | Installation Instructions - Page 15
    Electrical Connection (3-wire) Note: If you have a 4-wire connection, see following section for 4-wire connection instructions. WARNING ELECTRICAL SHOCK HAZARD To avoid risk or electrical shock, personal injury or death; grounding product to the frame of the unit may or may
  • Viking RVDR3302 | Installation Instructions - Page 16
    Electrical Connection (3-wire) (cont.) Bare Wire Connection Eyelet Connection 4 1 1 To make a bare wire connection, use holes on the left side of the terminal block. To connect eyelet style wires, use holes on right side of terminal. 5 1 1 2 Attach line #1 (black) and line #2 (red) leads to
  • Viking RVDR3302 | Installation Instructions - Page 17
    Electrical Connection (4-wire) WARNING ELECTRICAL SHOCK HAZARD To avoid risk or electrical shock, personal injury or death; grounding product to the frame of the unit may or may not be permitted through your local codes. If ground to the frame is not permitted then a 4-conductor power cord must be
  • Viking RVDR3302 | Installation Instructions - Page 18
    Electrical Connection (4-wire) (cont.) Bare Wire Connection Eyelet Connection 4 1 1 To make a bare wire connection, use holes on the left side of the terminal block. To connect eyelet style wires, use holes on right side of terminal. 5 Feed supply cord up through hole in bottom of range back
  • Viking RVDR3302 | Installation Instructions - Page 19
    Leveling/Adjustments/Alignment 1 2 Measure the four corners in cutout area to verify if flooring is level. 3 For uneven or sloped floors, level unit with metal shims only, as the adjustment required may exceed the thread available in the leg. 4 Move unit into opening. 5 (03.9/58"cm) Check that
  • Viking RVDR3302 | Installation Instructions - Page 20
    Leveling/Adjustments/Alignments (cont.) 7 Set the high corner of range so that the top of side trim is 3/8" (0.95 cm) above countertop. Level range to high corner. Anti-tip Device Installation WARNING TIPPING HAZARD • THIS RANGE CAN TIP. • A CHILD OR ADULT CAN TIP THE RANGE AND BE KILLED. •
  • Viking RVDR3302 | Installation Instructions - Page 21
    Wall Mount Anti-tip Installation 1 2 3(9-.52/c8m") Measurement (A) Measure from floor to bottom of the anit-tip opening located on the back of range. This will be measurement (A). +1/2"(A(1).3 cm) Locate anti-tip bracket on rear wall with the top left corner at measurement (A) plus 1/2" (1.3 cm
  • Viking RVDR3302 | Installation Instructions - Page 22
    Floor Mount Anti-tip Installation Dim A from Rear Wall 3-7/8" WIthout Standoffs (9.8 cm) Dim A from Rear Wall 4-5/8" WIth Standoffs (11.7 cm) 1 A (2810-1.69/24cm" ) 2 1 1 Ø(.321/c8m") Refer to chart for dimension A based on whether or not standoffs are used with the rear trim device. Mark
  • Viking RVDR3302 | Installation Instructions - Page 23
    leak testing of the appliance must be conducted according to the manufacturer's instructions. Before placing appliance in operation, always check for gas leaks with be performed by your dealer, a qualified licensed plumber, or gas service company. 2 Slide range into place. Be sure anti-tip bracket
  • Viking RVDR3302 | Installation Instructions - Page 24
    Door Replacement 1 2 Carefully realign door on hinges. Slide in and down. 3 Open door completely. Fold latches forward until locked in place. Close door 24
  • Viking RVDR3302 | Installation Instructions - Page 25
    Final Preparation • All stainless steel body parts should be wiped with hot, soapy water and with a liquid cleaner designed for this material. If buildup occurs, DO NOT use steel wool, abrasive cloths, cleansers, or powders! If it is necessary to scrape stainless steel to remove encrusted
  • Viking RVDR3302 | Installation Instructions - Page 26
    under the control panel. Record the following information indicated below. You will need it if service is ever required. Model number Serial number Date of purchase Date installed Dealer's name Address These installation instructions should remain with the unit for future reference. 26
  • Viking RVDR3302 | Installation Instructions - Page 27
    27
  • Viking RVDR3302 | Installation Instructions - Page 28
    Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-845-4641 or visit our website at vikingrange.com 057142-000B EN (021518)
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

3 Series
Freestanding 30” Dual Fuel
Self-Clean Sealed Burner Range
Installation
RVDR3302 / CRVDR3302