Whirlpool WED75HEFW Dimension Guide
Whirlpool WED75HEFW Manual
![]() |
View all Whirlpool WED75HEFW manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool WED75HEFW manual content summary:
- Whirlpool WED75HEFW | Dimension Guide - Page 1
back venting only. For steam models only, inlet hose must not be kinked. Spacing for recessed area or closet installation All dimensions show recommended and minimum spacing allowed. ■■ Additional spacing should be considered for ease of installation and servicing. ■■ Additional clearances might be - Whirlpool WED75HEFW | Dimension Guide - Page 2
MODELS ONLY) REQUIREMENTS The dryer best Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice. Dimensions are for planning purposes only. For complete details, see Installation Instructions
![](/manual_guide/products/whirlpool-wed92hefw-dimension-guide-cfd2b58/1.png)
ELECTRIC DRYER
PRODUCT MODEL NUMBERS
W10775223A
12/2015
WED7505F, WED7540F, WED7590F, WED75HEF,
WED7740F, WED77HEF, WED90HEF, WED92HEF
Back view
Side view
Front view
Spacing for recessed area or closet installation
All dimensions show recommended and minimum spacing allowed.
■
Additional spacing should be considered for ease of installation and servicing.
■
Additional clearances might be required for wall, door, and floor moldings.
■
Additional spacing should be considered on all sides
of the dryer to reduce noise transfer.
■
For closet installation with a door, minimum ventilation openings in the top and bottom of
the door are required. Louvered doors with equivalent ventilation openings are acceptable.
■
Companion appliance spacing should also be considered.
Recommended installation clearances
27"
(686 mm)
38
3
/
4
" Min.
(984 mm)
39" Max.
(990 mm)
NOTE:
Most
installations require
a minimum of
5" (127 mm)
clearance behind
dryer for exhaust
vent with elbow.
See “Venting
Requirements.”
*Approx. measurement.
6
1
/
2
"
(165 mm)
29
7
/
8
"*
(759 mm)
3
1
/
2
"*
(89 mm)
6
1
/
8
"*
(156 mm)
14
3
/
8
"
(365 mm)
3
/
4
"*
(18 mm)
Power supply
cord/cable
Water inlet
(Steam models
only)
Vent
18" min.
(457 mm)
1"
(25 mm)
24 in.
2
min.
(155 cm
2
)
48 in.
2
min.
(310 cm
2
)
3"
(76 mm)
3"
(76 mm)
1"
(25 mm)
0"–5"*
(0 mm–127 mm)
*0" (0 mm) spacing is allowed for straight-back venting only.
For steam models only, inlet hose must not be kinked.