Yamaha AD824 AD824 Owners Manual
Yamaha AD824 Manual
 |
View all Yamaha AD824 manuals
Add to My Manuals
Save this manual to your list of manuals |
Yamaha AD824 manual content summary:
- Yamaha AD824 | AD824 Owners Manual - Page 1
AD CONVERTER Owner's Manual WORD CLOCK INTERNAL 44.1kHz 48kHz BNC SLOT PEAK NOMINAL SIGNAL PEAK NOMINAL SIGNAL +48V +48V 1 2 3 4 5 6 7 8 SEL SEL GAIN dB POWER ON OFF +48V MASTER OFF ON AD CONVERTER Keep This Manual For Future Reference. E - Yamaha AD824 | AD824 Owners Manual - Page 2
instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha "ON", please try to eliminate the problem by using one of the following measures: afdankt of de volgende Yamaha Service Afdeiing: Yamaha Music Nederland Service Afdeiing Kanaalweg 18-G, 3526 - Yamaha AD824 | AD824 Owners Manual - Page 3
only to an AC outlet of the type stated in this Owner's Manual or as marked on the AD824. Failure to do so is a fire and electrical shock hazard. continue using the unit without heeding this instruction, fire or electrical shock may result. • Do not remove the AD824's cover. You could receive an - Yamaha AD824 | AD824 Owners Manual - Page 4
interference is a problem, relocate the affected equipment. AD824 Exclusion of Certain Responsibility Manufacturer, importer, or dealer shall not be liable for any incidental damages including personal injury or any other damage caused by improper use or operation of the AD824. Yamaha cannot be held - Yamaha AD824 | AD824 Owners Manual - Page 5
Teac are registered trademarks of Teac Corporation. Yamaha is a trademark of Yamaha Corporation. All other trademarks are the property of their respective holders and are hereby acknowledged. Copyright No part of the AD824 software or this Owner's Manual may be reproduced or distributed in any form - Yamaha AD824 | AD824 Owners Manual - Page 6
Cord 1 Turning On the Power 1 2 Touring the AD824 2 Front Panel 2 Rear Panel 3 3 Operation 5 Phantom Power Master 6 Setting the Gain 6 Controlling the AD824 Remotely 6 4 Digital I/O Cards 7 About Digital I/O Computer Connection 11 Yamaha DME32 Connection 12 Multiple AD824 Connection 13 6 - Yamaha AD824 | AD824 Owners Manual - Page 7
mini YGDAI (Yamaha General Digital Audio Interface) cards offer a variety of digital output interfaces, with support for all the manual, or mounted in a rack. When mounting the AD824 in a rack, leave adequate ventilation space around the AD824 (at least 10 cm of free space behind). If the AD824 - Yamaha AD824 | AD824 Owners Manual - Page 8
for more information. F WORD CLOCK indicators These indicators show the selected wordclock source. When the AD824 cannot lock to the selected source, the corresponding indicator flashes. G WORD CLOCK Source button This for use with the gain and +48V phantom power functions. AD824-Owner's Manual - Yamaha AD824 | AD824 Owners Manual - Page 9
AD824's GAIN controls and switches. Although Yamaha do not make such a cover, the AD824 Rear Panel 2 3 4 5 67 NVERTER AD824 RS422 COM PC RS422 WORD CLOCK OUT 75Ω Power cable The power cable is used to connect the AD824 to an AC outlet. See "Connecting the Power Cord" AD824 to the next AD824 in - Yamaha AD824 | AD824 Owners Manual - Page 10
9-pin D-sub connector is for connecting the AD824 to a device for remote control, such as a Yamaha DME32 or personal computer. It's also used to connect to the previous AD824 in a multiple-unit system. E WORD CLOCK follows: tip=hot, ring=cold, and sleeve=ground. ground hot cold AD824-Owner's Manual - Yamaha AD824 | AD824 Owners Manual - Page 11
and lights up continuously. The indicator of previously selected wordclock source goes out. When the AD824 cannot lock to the selected wordclock source, the corresponding indicator flashes. See page 14 for lights up when the phantom power is on, and goes off when it's turned off. AD824-Owner's Manual - Yamaha AD824 | AD824 Owners Manual - Page 12
, or PC when it's connected to a PC. Note: When connecting to an AD824's COM PC/RS422 port and COM RS422 port, be careful not to create a loop connection between them. See "Personal Computer Connection" on page 11 and "Yamaha DME32 Connection" on page 12 for hookup examples. AD824-Owner's Manual - Yamaha AD824 | AD824 Owners Manual - Page 13
Yamaha Professional Audio yamaha.co.jp/product/proaudio/homeenglish/>. MY8-AT-ADAT The MY8-AT card provides ADAT format digital I/O via two MultiChannel Optical Digital Interface connectors, and supports pin D-sub connector, and supports 16-, 20-, and specifications for the AD824-compatible I/O cards. Card - Yamaha AD824 | AD824 Owners Manual - Page 14
fixing screws in a safe place for future use. 3 Insert the card between the guide rails and slide it all the way into the slot, as shown below. You may have to push firmly to plug the card into the AD824 connector. COM PC RS422 OUT SLOT WORDOCN7L5OΩCK OFF IN 8 8 8 4 Secure the - Yamaha AD824 | AD824 Owners Manual - Page 15
Yamaha the AD824 can AES/EBU cable AD824 SLOT: MY8-AE example shows how the AD824 can be connected AD824 is the wordclock master. In order to use the digital audio device as the wordclock master, its wordclock signal would need to be fed to the AD824 ADAT I/O ADAT cable AD824 OUT SLOT: MY8-AT - Yamaha AD824 | AD824 Owners Manual - Page 16
supplied with the MY8-AE I/O card. The digital audio device is the wordclock master, with the AD824 receiving its wordclock via a BNC connection, the DA824, via its slot input. Digital Audio Device (DME32 8 LOCK POWER ON OFF DA CONVERTER Analog input x8 Analog output x8 AD824-Owner's Manual - Yamaha AD824 | AD824 Owners Manual - Page 17
D24, etc.) AES/EBU I/O AES/EBU cable AD824 SLOT: MY8-AE Input OUT INSERT Output IN WORD can be connected to the AD824 for remote control. The computer is connected to the AD824's COM PC/RS422 port, /RS422 switch is set to PC. Serial cable AD824 COM PC/RS422 WORD CLOCK INTERNAL 44.1kHz 48kHz - Yamaha AD824 | AD824 Owners Manual - Page 18
AD824 can be connected to the Yamaha DME32 Digital Mixing Engine for remote control. Channel gain and phantom power can be remotely controlled and recalled from the DME32, which features Gain Trimmer components especially for use with the AD824 OFF ON AD CONVERTER AD824 DA824 Analog input x8 - Yamaha AD824 | AD824 Owners Manual - Page 19
AD824 #1 is connected to the COM PC/RS422 port on AD824 #2. The COM PC/RS422 switches on both AD824s are set to RS422. The DME32 is the wordclock master and both the AD824s MIXING ENGINE COM 9-pin cable AD824 #1 SLOT WORD CLOCK INTERNAL input x8 9-pin cable AD824 #2 SLOT WORD CLOCK INTERNAL - Yamaha AD824 | AD824 Owners Manual - Page 20
AD824 is wordclock locked to the digital audio device connected to its SLOT output. The AD824 the AD824 can lock AD824 sources its wordclock signal from its SLOT. Note that the AD824 AD824 must be connected to the digital audio device. In this example, the AD824 Wordclock AD824 MY8- Wordclock AD824 - Yamaha AD824 | AD824 Owners Manual - Page 21
device, although it depends on the distribution method being used. The AD824's WORD CLOCK 75Ω ON/OFF switch allows the AD824 to be connected in a variety of ways. The following examples -B Termination = OFF Wordclock slave WC IN (BNC) Device-C Termination = ON Wordclock slave AD824-Owner's Manual - Yamaha AD824 | AD824 Owners Manual - Page 22
16 Appendix Appendix Error Messages The AD824 performs several diagnostic checks when it's turned on. If a problem is detected, one of the following error codes appears briefly on the GAIN Phantom power master on/off POWER Power on/off Gain display 3-digit, 7-segment LED AD824-Owner's Manual - Yamaha AD824 | AD824 Owners Manual - Page 23
60˚ C (-4˚ F to 140˚ F) Relative humidity 10%-95% Power cord length 1.9 m Supplied accessories Owner's Manual, 9-pin D-sub crossed cable (1.5m) Options MY8-AT, MY8-TD, MY8-AE mini YGDAI I/O cards 1. dB represents a specific voltage, 0 dB is referenced to 0.775 V rms. AD824-Owner's Manual - Yamaha AD824 | AD824 Owners Manual - Page 24
/User Information specified in EN55103-1 and EN55103-2. Inrush Current: 10A Conformed Environment: E1, E2, E3 and E4 V546100 R0 1 IP 24 AD824-Owner's Manual 00 05 1000 CP Printed in Japan YAMAHA CORPORATION Pro Audio & Digital Musical Instrument Division P.O. Box 3, Hamamatsu, 430-8651, Japan
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
 |
 |
AD CONVERTER
Owner’s Manual
E
ON
OFF
POWER
AD CONVERTER
1
2
3
4
5
6
7
8
PEAK
SIGNAL
NOMINAL
PEAK
SIGNAL
+48V
SEL
NOMINAL
+48V
WORD CLOCK
INTERNAL
44.1kHz
BNC
SLOT
48kHz
SEL
dB
GAIN
OFF
ON
+48V MASTER
Keep This Manual For Future Reference.