Yamaha RX-V470 Owner's Manual

Yamaha RX-V470 Manual

Get Yamaha RX-V470 PDF manuals and user guides View all Yamaha RX-V470 manuals
Add to My Manuals
Save this manual to your list of manuals

Yamaha RX-V470 manual content summary:

  • Yamaha RX-V470 | Owner's Manual - Page 1
    ENGLISH s RX-V470 Natural Sound Stereo Receiver CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. ÷ Explanation of Graphical Symbols The lightning
  • Yamaha RX-V470 | Owner's Manual - Page 2
    the operating instructions or as marked on the appliance. 11 Power-Cord Protection - Power- 15 Damage Requiring Service - The appliance should be serviced by qualified service personnel when: of the mast and supporting structure, grounding of sounds is often undetectable until it is too late, YAMAHA
  • Yamaha RX-V470 | Owner's Manual - Page 3
    instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha try to eliminate the problem by using one of (circuit breaker or fuse) circuits or 7 Always set the volume control to "- " before starting to read the "Troubleshooting" section on common
  • Yamaha RX-V470 | Owner's Manual - Page 4
    you for selecting this YAMAHA stereo receiver. SUPPLIED ACCESSORIES FEATURES After unpacking, check that the following parts are contained. ÷ Indoor FM Antenna ÷ AM Loop Antenna ÷ Remote Control Transmitter ÷ Batteries (size AA, R6, UM-3) 5-Speaker Configuration Front: 50W + 50W (8 ) RMS
  • Yamaha RX-V470 | Owner's Manual - Page 5
    ENGLISH PROFILE OF THIS UNIT You are the proud owner of a Yamaha RX-V470 stereo receiver -an extremely sophisticated audio component. The Digital Sound Field Processor (DSP) built into this unit takes full advantage of Yamaha's undisputed leadership in the field of digital audio processing to bring
  • Yamaha RX-V470 | Owner's Manual - Page 6
    present stereo speaker system. The rear speakers are used for the output of the effect sound. And the center speaker is used for the output of the center sound (dialog etc.) encoded with the Dolby Surround. The rear and center speakers do not need to be equal in power to the front speakers. However
  • Yamaha RX-V470 | Owner's Manual - Page 7
    to R, "+" to "+" and "-" to "-". Also, refer to the owner's manual for each component to be connected to this unit. Video cassette recorder AUDIO IN VIDEO TAPE PB REC OUT L R R AUDIO SIGNAL See the next page. (U.S.A. model) SPEAKERS FRONT + R - - L+ A A B B AC OUTLETS « To AC outlet
  • Yamaha RX-V470 | Owner's Manual - Page 8
    REAR CENTER L REAR + - 3 2 Center speaker Right Left Front speakers B Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut to be as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the
  • Yamaha RX-V470 | Owner's Manual - Page 9
    a 300-ohm feeder or a coaxial cable may be used. In locations troubled by electrical interference, a coaxial cable is preferable. 300-ohm GND AM ANT 2 AM antenna cable 13 2 Place the AM antenna away from the receiver and orient so that the best reception is obtained. ÷ The antenna may be hung
  • Yamaha RX-V470 | Owner's Manual - Page 10
    best performance of the digital sound field processor. 1 Turn off the power and set the VOLUME control to the " " position. VOLUME 5 Turn on the power. POWER 0 -dB 2 Select the front speakers to be used. SPEAKERS A B ON _ ON OFF - OFF ÷ If you use two front speaker systems, press both the
  • Yamaha RX-V470 | Owner's Manual - Page 11
    is pressed again to complete the adjustment. 9 Turn up the volume. VOLUME 10 10Adjust the BALANCE control so that the sound output level of the left front speaker and the right front speaker are the same. BALANCE 0 TEST L5 5R Adjust while the L or R indicator is lit. 3 CONTINUED 0 -dB
  • Yamaha RX-V470 | Owner's Manual - Page 12
    to adjust listening volume. Do not change any other volume settings on this unit. 12Make the sound output level of the rear speakers the same as that of the front speakers with the REAR level control. REAR TEST 0 10 Adjust while the S indicator is lit. 13After completing the level adjustment
  • Yamaha RX-V470 | Owner's Manual - Page 13
    TUNER CD PHONO The corresponding indicator lights on the display. (When TUNER is selected, the previously received frequency appears on the display.) 4 Select the front speakers to be used. SPEAKERS A B ON _ ON OFF - OFF ÷ If you use two front speaker systems, press both the A and B switches
  • Yamaha RX-V470 | Owner's Manual - Page 14
    VCR MONITOR input selectors are not selected. 2 Play the source and then turn the VOLUME control up to confirm the input source. ÷ The VOLUME, BALANCE, BASS, TREBLE and DSP (Digital Sound field Processor) control settings have no effect on the recording. 3 Set the tape deck or VCR to the recording
  • Yamaha RX-V470 | Owner's Manual - Page 15
    to increase (or counterclockwise to decrease) the low frequency response. BASS DEFEAT L5 5R -5 5+ Note These controls are effective only for the sound from the front speakers. TREBLE: Turn this clockwise to increase (or counterclockwise to decrease) the high frequency response. TREBLE DEFEAT
  • Yamaha RX-V470 | Owner's Manual - Page 16
    If you tune in an FM station manually, it is received in monaural mode automatically to obtain the sound quality. 1 Displays the band and frequency of the received station. 2 Lights when an FM stereo broadcast with sufficient signal strength is received (in automatic tuning mode only). 3 Indicates
  • Yamaha RX-V470 | Owner's Manual - Page 17
    be received by pressing stereo or monaural) is stored along with the station frequency. 5 Press the MEMORY button. MEMORY \ PRESET FM MHz Shows the displayed station has been stored in A1. ÷ Perform steps 1 through 5 to store other stations. Memory back-up The memory back-up circuit
  • Yamaha RX-V470 | Owner's Manual - Page 18
    This presents you the best surround condition without adjusting it manually. ÷ To use the DSP function, it is necessary to adjust the sound output level balance between the front, rear and/or center speakers beforehand. (Refer to "ADJUSTMENT BEFORE OPERATION".) Controls and indicators for DSP Main
  • Yamaha RX-V470 | Owner's Manual - Page 19
    center mode is in the PHANTOM, the front speakers output the sound of the center speaker. ÷ When this unit is in the Dolby Pro Logic Surround mode, if the main-source sound is considerably altered by overadjustment of the BASS or TREBLE controls, the relationship between the center and rear channels
  • Yamaha RX-V470 | Owner's Manual - Page 20
    you prefer to cancel the DSP mode, press the EFFECT button. The sound will be the normal 2-channel stereo without surround sound effect. Delay time adjustment ÷ The delay time can be adjusted with the remote control transmitter only. You can adjust the time difference between the beginning of the
  • Yamaha RX-V470 | Owner's Manual - Page 21
    ) If desired, you can adjust the effect sound output level of the front speakers with the FRONT EFFECT level control. FRONT EFFECT Adjustment of the rear level If desired, you can adjust the sound output level of the rear speakers with the REAR level control even if the output level is already set
  • Yamaha RX-V470 | Owner's Manual - Page 22
    only with the remote control transmitter. ÷ The components on which the SLEEP timer is effective are the sources connected to a SWITCHED OUTLET on the rear panel of this unit. To set the SLEEP timer Display the desired time with the SLEEP button. SLEEP Each time the SLEEP button is pressed
  • Yamaha RX-V470 | Owner's Manual - Page 23
    REC MUTE VCR MON CENTER MODE ŸPRO LOGIC-ENHANCED CNCT VIDEO ŸSURROUND + MONO MOVIE ROCK HALL DELAY TIME - EFFECT - VOLUME + STANDBY mode (Europe model only) While the power is on, pressing the POWER button on the remote control transmitter switches the unit to the STANDBY mode. (In this
  • Yamaha RX-V470 | Owner's Manual - Page 24
    portion of the lid in until it clicks into place. Notes ÷ There should be no large obstacles between the remote control transmitter and the main unit. ÷ If the remote control sensor is directly illuminated by strong lighting (especially an inverter type of fluorescent lamp etc.), it might cause the
  • Yamaha RX-V470 | Owner's Manual - Page 25
    disconnect the power cord and contact your authorized YAMAHA dealer or service center for help. Amplifier SYMPTOM The unit fails to turn on when the POWER switch is pressed. No sound or no picture. The sound from all speakers or only from the front speakers suddenly goes off. CAUSE Power cord is
  • Yamaha RX-V470 | Owner's Manual - Page 26
    . total [Australia and U.K. models] ......... 1 SWITCHED OUTLET 100 W max. total Dimensions (W x H x D 435 x 131 x 292 mm (17-1/8" x 5-3/16" x 11-1/2") Weight 7.2 kg (15 lbs. 14 oz.) Accessories AM loop antenna Indoor FM antenna Remote control transmitter Batteries Specifications are subject to
  • Yamaha RX-V470 | Owner's Manual - Page 27
    CAMPANULES, LOGNES 77321 MARNE LA VALLEE CEDEX 2 FRANCE YAMAHA ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD1 7JS, ENGLAND YAMAHA SCANDINAVIA A.B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VASTRA FRÖLUNDA, SWEDEN YAMAHA MUSIC AUSTRALIA PTY, LTD. 17-33 MARKET ST., SOUTH
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
Natural Sound Stereo Receiver
s
RX-V470
CAUTION:
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR BACK) NO
USER-SERVICEABLE PARTS INSIDE, REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
OWNER'S MANUAL
IMPORTANT!
Please record the serial number of this unit in the space
below.
Model:
Serial No.:
The serial number is located on the rear of the unit.
Retain this Owner’s Manual in a safe place for future
reference.
WARNING
To reduce the risk of fire or electric shock, do not expose
this unit to rain or moisture.
÷
Explanation of Graphical Symbols
The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert you to the presence
of uninsulated “dangerous voltage” within the product's
enclosure that may be of sufficient magnitude to constitute a
risk of electric shock to persons.
The exclamation point within an equilateral triangle is
intended to alert you to the presence of important operating
and maintenance (servicing) instructions in the literature
accompanying the appliance.