1996 Buick Park Avenue Owner's Manual - Page 144

Temperature Button To adjust the comfort level you want maintained inside the vehicle, push the TEMP button. If you wanta you warrner comfort level, push the red arrow. If want a cooler comfort level, push the blue arrow. Your comfort setting is shownin the display. Automatic Operation Press the AUTO button when you want the system to automatically adjust to changes in the temperature inside the vehicle, the outside temperature and the load on sun the vehicle. When the system is for automatic set operation, air willcome from the floor, middleor windshield outlets dependingon the temperature inside the vehicle, theoutside temperature and sun load. Fan speed will vary as the system gets and maintains the to comfort setting you have selected through the use of the TEMP button. To find your comfort setting, start with the system in AUTO mode and the TEMP button adjusted to a display of 75°F (24"C), give the vehicle about 20 minutes to stabilize, and adjust your comfort setting if necessary, by using the TEMP button. The display will show the comfort setting for a few seconds and then it will display the outside temperature.If you want to see your current automatic fan speed, airflow direction and comfort setting, press theAUTO button. In cold weather, the system will delay turning the on fan, to avoid blowing cold air. length of the delay The depends on theengine coolant temperature and the outside temperature. Pushing the FAN, AIR FLOW or FRONT buttons will override this delay, turn off the AUTO setting andchange the fan speed. Fan Button The speed of the blowerfan iscontrolled automatically if you have the system set for AUTO. Pressing the FAN button will display and hold the current blower fan setting. If you want the blower to run at a lower speed, push fan the bottom of the FAN button. The fan speed will decrease with every push of the button until thelowest speed is reached. If you want increase the fanspeed, to push the top of the FAN button. Notice thefan indicators on the display. Mode Controls Press the AIRFLOW button to deliver air through the floor, middle or windshield outlets. The system will stay in the selected mode until the AUTO button is pushed. Press the up arrowon the AIR FLOW button to cycle through the available modes. 3-4