1996 Buick Park Avenue Owner's Manual - Page 165

SOURCE: Press this button to change to the tape or disc function when the radio is on. If both a tape and a disc are installed, the system will first go to tape play; TAPE will appear on the display. If SOURCE is pressed again, the system will go to disc play; CD will appear on the display. EJECT The system has two EJECT buttons. Press the button near the CD slot to remove a disc. Press the button near the tape slot to remove a tape. The radio will play. CLN: This message may appear on the display. If it does, your cassette tape player needs to be cleaned. It will still play tapes, but you should clean it as soon as possible to prevent damage to your tapes and player.See "Care of Your Cassette Tape Player" in the Index. After you clean the player, press and holdEJECT for five seconds to reset the CLN indicator. The radio will display --- to show the indicator was reset. Your cassette tape player automatically reduces background noise from tapes encoded with Dolby N R . You may turn Dolby off by pressing the number six preset. Dolby Noise Reduction is manufactured under a license from Dolby Laboratories Licensing Corporation. Dolby and the double-D symbol are trademarks of Dolby Laboratories Licensing Corporation, Playing a Campact Disc Insert a disc partway into the slot, label side up. r n e player will pull it in. The disc should begin playing. If you want to insert a CD while the ignition or the radio is off, first press EJECT or RECALL. If you're driving on a very rough roador if it's very hot, the disc may not play and an error code may appear on the display. PressRECALL to take theerror code off the display. When things get back to normal, the disc should play. If the disc comes out, it could be that: 0 The disc is upside down. It is dirty, scratched or wet. It is very humid. (If so, wait about an hour and try again.) 0 0 RECALL: Press this button to see which track is playing. Press it again within five seconds to see how long it has been playing. To change what is normally shown on the display (track or elapsed time), press the RECALL button until you see the display you want, then hold theRECALL button until the displayflashes. 3-25