2003 Buick LeSabre Owner's Manual - Page 117

Reprogramming a Single HomeLink@ Button To program a device to HomeLink@ using a HomeLink@ button previously trained, follow these steps: Resetting Defaults To reset HomeLink@ to default settings do the following: 1. Hold down the two outside buttons for about 20 seconds until the indicator light begins to flash. 2. Continue to hold both buttons until the HomeLink@ indicator light turns off. 1. Press and hold the desired HomeLink@button. Do not release the button. 2. The indicator light will begin to flash after 20 seconds. While still holding the HomeLink@ button, proceed with Step 2 under "Programming HomeLink@." 3, Release both buttons. For questions or comments, contact HomeLink@ at 1-800-355-3515, or on the internet at www.homelink.com. 2-46