2013 Buick Regal Owner Manual - Page 213

Driving and Operating The key lock release will not work if the battery is charged less than 9 volts, or uncharged. Try charging or jump starting the battery. See Jump Starting (On-board with eAssist Only) on page 10‑85 or Jump Starting (with or without eAssist) on page 10‑87 If charging or jump starting the battery does not work, there is a manual key lock release. Locate the hole below the ignition lock. Insert a tool or key into the opening. Locate the lever, and press it toward the driver while removing the key from the ignition. 9-17 Ignition Positions (Keyless Access) strong radio antenna signal causing interference to the keyless access system. See Remote Keyless Entry (RKE) System Operation on page 2‑3 for more information. To shift out of P (Park), the vehicle must be in ON/RUN and the brake pedal must be applied. Stopping the Engine/OFF (No Indicator Lights): When the vehicle is stopped, press the engine START/STOP button once to turn the engine off. If the vehicle is in P (Park), the ignition will turn off, and Retained Accessory Power (RAP) will remain active. See Retained Accessory Power (RAP) on page 9‑23 for more information. If the vehicle is not in P (Park), the ignition will return to ACC/ ACCESSORY and display a message in the Driver Information Center (DIC). See Transmission Messages on page 5‑34 for more The vehicle has an electronic keyless ignition with pushbutton start. Pressing the button cycles it through three modes, ACC/ACCESSORY, ON/RUN/START, and Stopping the Engine/OFF. The transmitter must be in the vehicle for the system to operate. If the pushbutton start is not working, the vehicle may be near a