2015 Buick Encore Owner Manual - Page 131

5-24 Instruments and Controls displays on the cluster and DIC to either metric or English (US) measurements. Remaining Oil Life This display shows an estimate of the oil's remaining useful life. If REMAINING OIL LIFE 99% is displayed, that means 99% of the current oil life remains. When the remaining oil life is low, the CHANGE ENGINE OIL SOON message will appear on the display. See Engine Oil Messages on page 5-26. The oil should be changed as soon as possible. See Engine Oil on page 10-7. In addition to the Engine Oil Life System monitoring the oil life, additional maintenance is recommended in the Maintenance Schedule in this manual. See Maintenance Schedule on page 11-2 for more information. Remember, the Remaining Oil Life display must be reset after each oil change. It will not reset itself. Also, be careful not to reset the Remaining Oil Life display accidentally at any time other than when the oil has just been changed. It cannot be reset accurately until the next oil change. To reset the Engine Oil Life System, press SET/ CLR while the Remaining Oil Life display is active. See Engine Oil Life System on page 10-9. Tire Pressure The display will show a vehicle with the approximate pressures of all four tires. Tire pressure is displayed in either kilopascal (kPa) or pounds per square inch (psi). See Tire Pressure Monitor System on page 10-44 and Tire Pressure Monitor Operation on page 10-45 for more information. briefly while Timer is displayed. To reset the timer to zero, press and hold SET/CLR. Navigation This display is used for the Navigation System Turn-by-Turn guidance. See the infotainment manual, if the vehicle has navigation, for more information. Vehicle Information Menu Items Press MENU on the turn signal lever until the Vehicle Information Menu is displayed. Use w / x to scroll through the following menu items: ... Unit Remaining Oil Life Tire Pressure Compass The vehicle has a compass display in the DIC. See Compass on page 5-4 for more information. Unit Move w / x to switch between metric or US when the Unit display is active. Press SET/CLR to confirm the setting. This will change the