2015 Buick Regal Owner Manual - Page 39

2-8 Keys, Doors, and Windows 6. Remove the transmitter from the transmitter pocket and press K. To program additional transmitters, repeat Steps 4-6. When all additional transmitters are programmed, press and hold the ENGINE START/STOP button for 12 seconds to exit programming mode. 4. Place the new transmitter into the transmitter pocket with the buttons facing up. The transmitter pocket is located inside the center console cupholder. The cupholder liner will need to be pulled out to access the transmitter pocket. 5. Press the ENGINE START/ STOP button. When the transmitter is learned, the DIC will show that it is ready to program the next transmitter. Starting the Vehicle with a Low Transmitter Battery If the transmitter battery is weak or if there is interference with the signal , the DIC may display NO REMOTE DETECTED or NO REMOTE KEY WAS DETECTED PLACE KEY IN TRANSMITTER POCKET THEN START YOUR VEHICLE when you try to start the vehicle. The REPLACE BATTERY IN REMOTE KEY message may also be displayed at this time. To start the vehicle: 1. Remove the cupholder liner from the center console cupholder. 2. Place the transmitter in the transmitter pocket with the buttons facing up. 3. With the vehicle in P (Park) or N (Neutral), press the brake pedal and the ENGINE START/ STOP button. See Starting the Engine on page 9-18 for additional information about the vehicle's keyless ignition with pushbutton start. Replace the transmitter battery as soon as possible.