2003 Cadillac Seville Owner's Manual - Page 122

Your vehicle may be equipped with RainsenseTM ii wipers. The moisture sensor for this feature is mounted on the interior side of the windshield below the rearview mirror and is used to automatically operate the wipers by monitoring the amount of moisture build-up on the windshield. Wipes occur as needed to clear the windshield depending on driving conditions and the sensitivity setting. In light rain or snow, fewer wipes will occur. In heavy rain or snow, wipes will occur more frequently. The RainsenseTM wipers operate in a delay mode as well as a continuous low or high speed as needed. If the system is left on for long periods of time, occasional wipes may occur without any moisture on the windshield. This is normal and indicates that the RainsenseTM system is activated. The RainsenseTM system can be activated by moving the wiper stalk up to the INT position and turning the INT ADJ band to one of the five sensitivity levels. The bottom INT ADJ position is the lowest sensitivity setting, level one. This allows more rain or snow to collect on the windshield between wipes. Turning the INT ADJ band away from you to thehigher sensitivity levels allows less rain or snow to collect on the windshield between wipes. The top positior! is the highest sensitivity setting, !eve! five. A single wipe will occur each time you turn the INT ADJ band to a higher sensitivity level to indicate that the sensitivity level has been increased. Notice: The wipers must be turned off when going through a car wash to avoid damage. The MIST and "wash" cycles operate as normal and are not affected by the RainsenseTMfunction. The RainsenseTMsystem can be overridden at any time by manually changing the wiper control to LO or HI speed. When RainsenseTM active, the headlamps will turn on is automatically. The headlamps will turn off again once the wipers turn off if it is light enough outside. If it is dark, they will remain on. See Wiper-Activated 75 Headlamps under Exterior Lamps on page 3- for more information. pytpri~r glass Nofice: Do not place stickers or other items on the s11-f3pp &ri~t!\/ IE frnnt nf thn J moisture sensor. Doing this could cause the moisture sensor to malfunction. 3-11