2003 Cadillac Seville Owner's Manual - Page 274

I . A.fter removing the engine air c!eaner!?i!ter assembly to reach the transaxle fluid cap, turn the cap counterclockwiseto remove. Pull out the dipstick and wipe it with a clean rag or paper towel. 2. Push it back in all the way, wait three seconds and then pull it back out again. IIUVV UA.I. +n LU nuu rlulu A 44 C I . m : A Refer to the Maintenance Scneduie to determine what kind of transaxle fluid to use. See Part D: Recommended Fluids and Lubricants on page 6-15. If the fluid level is low, add only enough of the proper fluid to bring the level into the cross-hatched area on the dipstick. 1. Pull out the dipstick. 2. Using a long-neck funnel, add enough fluid at the dipstick hole to bring it to the proper level. It doesn't take much fluid, generally less than one pint (0.5 L). Don't overfill. 3. Check both sides of the dipstick, and read the lower level. The fluid level must be in the cross-hatched area. 4. If the fluid level is in the acceptable range, push the dipstick back in all the way and turn the handle clockwise. Reinstall the e q i n e air cleanedfilter assembly. Notice: We recommend you use only fluid labeled DEXRON@-Ill, because fluid with that label is made especially for your automatic transaxle. Damage caused by fluid other than DEXRON@-III is not covered by your new vehicle warranty. 3. After adding fluid, recheck the fluid level as dnsrr??nd %-!de!, F!c?!Y ?c? Check. 4. When the correct fluid level is obtained, push the dipstick back in all the way and turn the handle clockwise. Reinstall the engine air cleaner/filter assembly. 5-25