2007 Cadillac DTS Owner's Manual - Page 189

• The other vehicle's lamp(s) cannot be detected • • • due to dense exhaust, smoke, fog, snow, road spray, mist, or other airborne obstructions. Your vehicle's windshield is dirty, cracked, or obstructed by something that blocks the view of the IntelliBeam™ light sensor. Your vehicle's windshield is covered with ice, dirt, haze, or other obstructions. Your vehicle is loaded such that the front end of the vehicle points upward, causing the IntelliBeam™ sensor to aim high and not detect headlamps and taillamps. You are driving on winding or hilly roads. Disabling and Resetting IntelliBeam™ at the Rearview Mirror IntelliBeam™ can be disabled by using the controls on the inside rearview mirror. AUTO 3 (On/Off): To disable the system, press this button on the inside rearview mirror. The IntelliBeam™ indicator turns off and does not come back on until the IntelliBeam™ button is pressed again. When IntelliBeam™ has turned on the high-beams, pull or push the high-beam stalk. This will disable IntelliBeam™. The IntelliBeam™ indicator on the mirror turns off. To turn IntelliBeam™ back on, press the IntelliBeam™ button on the mirror. A different sensitivity setting is available for dealer diagnostics. This is done by pushing and holding this button for 20 seconds until the IntelliBeam™ indicator light flashes three times. If you accidentally activate this, the vehicle' s setting automatically is reset when the ignition is turned off and then on again. • You might need to manually disable or cancel the high-beam headlamps by turning the low-beam headlamps on, if any of the above conditions exist. 189