2007 Cadillac DTS Owner's Manual - Page 268

AudioPilot®: If your vehicle has the Bose® Premium audio, the system has AudioPilot® noise compensation technology. To use AudioPilot press the Automatic Volume Control screen button to access the AudioPilot® menu and then press the ON screen button. AudioPilot® automatically adjusts the volume level of the audio so that it always sounds the same. The feature is most effective at lower volume settings where background noise can be louder than the audio. At high volume settings there might be little or no change in the audio level. In some cases where the noise level changes quickly, you can hear the audio level changing. This is normal. For more information on AudioPilot®, visit www.bose.com. To activate AudioPilot®, do the following steps: 1. Set the radio volume to the desired level. 2. Press the MENU button to display the radio setup menu. 3. Press the pushbutton located under the AUTO VOLUM label on the radio display. 4. Press the ON or OFF button to turn this feature on or off. 268 ® Finding a Station BAND: Press this button to switch between AM, FM, or XM™ (if equipped). The selection displays. a (Tune): Turn this knob to select radio stations. © SEEK ¨: Press the right or left SEEK arrow to go to the next or to the previous station and stay there. To scan stations, press and hold either SEEK arrow for three seconds until a beep sounds. The radio goes to a station, plays for a few seconds, then goes to the next station. Press either SEEK arrow again to stop scanning. The radio only seeks and scans stations with a strong signal that are in the selected band.