1996 Chevrolet Camaro Owner's Manual - Page 76

Mode 3: Horn and LampdLamps (If you use the r transmitter toa m the system,your parking lamps will flash and your horn will chirp twiceto verify that the system is armed. If you use eitherthe power door lock switch or passive arming, only your lamps will flash for verification). Mode 4: Lamps (When your vehicle arms,only your parking lamps will flash for verificiition). Mode 1: Zero Delay and Shock Sensor Disabled (The alarm will sound immediately if the driver's door is opened with your key and the shock sensor will not be available to measure sharp blows to your vehicle). Mode 2: Eight Second Delay and Shock Sensor Disabled (The alarm will sound eight seconds after the driver's door is opened with your key and the shock sensor will not be available tomeasure sharp blows to your vehicle). Mode 3: Zero Delay and Shock Sensor Enabled (The alarm will sound immediately after the driver's door is opened with your key and the shock sensor will be available tomeasure sharp blows to your vehicle). Mode 4: Eight Second Delay and Shock Sensor Enabled (The alarm will sound eight seconds after the driver's door is opened with your key and the shock sensor will be available tomeasure sharp blows to your vehicle). Driver's Door Alarm Delay and Shock Sensor Enable Your vehicle comes with this feature set in Mode 4. This means that if you open the driver's door using your key, the alarm will not sound for eight seconds. Also the shock sensor, able to detect sharp blows to your vehicle is active. To change the factory setting, do the following: 1. Turn the parking lamps and off. on 2. Count the number of chimes you hear. The number of chimes tells you which mode your vehicle is set for. Leaving ProgrammingMode When programming is done, turn the ignition switch to the OFF position and replace the RADIO fuse. 3. Turn the parking lamps on and off until you hear the number of chimes that correspond to the mode selection you want. 2-21