1997 Chevrolet S10 Pickup Owner's Manual - Page 120

Finding a Station AM-FM: Press the lowerknob to switch between,AM and F M . The display shows your selection. In additionto the-four stations already set, up to three more stations may be preset on eachband by pressing. two adjoining buttons at the same time. Just: TUNE: Turn the lower knob tune in radio stations. to 1. Tune in the desired station. 2. Press S-ET.(SET will appear on the display.) 3. Press two adjoining pushbuttons at the same time, within five seconds. Whenever you press thesame two buttons, the station you set will return. 4. Repeat the steps for each pair of pushbuttons. SEEK: Press this button go to the next higher station to land stop. '1 'SCAN: Press this button to listen to. each station for a go few seconds. The fadio will to the next station, stop for a few seconds, then go to the next station. SCAN will appearon the display. Press SCAN again to stop scanning. PUS.HBUTTONS:The fournumbered pushbuttons let you return to your favorite stations. You can set up to 14 stations (seven A M and seven FM). Fist: 1. Turn the radio on. 2. Press AM-FILI to select the band. Setting theTone BASS: Slide this lever up- ordown to increaseor decrease bass. TREBLE: Slide this lever up or down to .increase or decrease treble. If a station is weak or noisy, you may want to decrease the treble. Adjusting the Speakers BAL: Turn the control behind the upper knob to move the sound to the left or right speakers. The middle position balances the sound between.the speakers. FADE: Turn the control behind. the lowex knob to move the sound to the front or rear speakers. The middle position balances the sound between the speakers. 3. Tune in the desired station. 4. Press SET. (SET will appear on the display.) 5. Press one of the four pushbuttons, within five seconds. Whenever you press that numbered button, the station you set will return. 6. Repeat the steps for each pushbutton. 3-7