2002 Chevrolet Silverado 1500 Pickup Owner's Manual - Page 289

Here is an example of proper truck and camper match: Your dealer can help you make a good vehicle-camper match. He'll also help you determine your CWR. After you've loaded your vehicle and camper, drive to a weigh station and weigh the front and rear wheels separately. This will tell you the loads on your axles. The loads on the front and rear axles shouldn't be more than either of the GAWRs. The total of the axle loads should not be more than the GVWR. Open your driver's door and look at the Certification/Tire label to find out your GAWR and GVWR. A. Camper Center of Gravity B. Recommended Center of Gravity Location Zone The camper's center of gravity should fall within the center of gravity zone for your vehicle's cargo load. You must weigh any accessories or other equipment that you add to your vehicle. Then, subtract this extra weight from the CWR. This extra weight may shorten the center of gravity zone of your vehicle. Your dealer can help you with this. If your slide-in camper and its load weighs less than the CWR, the center of gravity zone for your vehicle may be larger. If you've gone over your weight ratings, move or take out some things until all the weight falls below the ratings. Of course, you should always tie down any loose items when you load your vehicle or camper. When you install and load your slide-in camper, check the manufacturer's instructions. If you want more information on curb weights, cargo weights, Cargo Weight Rating and the correct center of gravity zone for your vehicle, your dealer can help you. Just ask for a copy of "Consumer Information, Truck-Camper Loading." 4-61