2005 Chevrolet SSR Pickup Owner's Manual - Page 118

To program memory settings to each button, use the following steps: 1. Adjust the driver's seat to the desired position. 2. Press the SET button. 3. Press and hold button 1 (for Driver 1) for three seconds. A double chime will sound to let you know that the position has been stored. A second seating position can be programmed by repeating the procedure with a second driver and pressing button 2 for three seconds. To recall a memory position, do one of the following: If you use the unlock button on the remote keyless entry transmitter to enter your vehicle, the preset driver's seat positions will be recalled if programmed to do so through the Driver Information Center (DIC). The numbers on the back of the transmitters, 1 or 2, correspond to the numbers on the memory controls. The seat positions can also be recalled by placing the key in the ignition if programmed to do so through the Driver Information Center (DIC). To stop recall movement of the memory feature at any time, press one of the power seat controls or memory buttons. Further programming for automatic seat can be done through the Driver Information Center (DIC). See DIC Vehicle Personalization on page 3-52 for more information. • If you have an automatic transmission vehicle, press and release the desired button 1 or 2 while the vehicle is in PARK (P). A single chime will sound and the memory position will be recalled. If the vehicle is not in PARK (P), the memory position will not be recalled. • If you have a manual transmission vehicle, press and release the desired button 1 or 2 while the vehicle is off. A single chime will sound and the memory position will be recalled. If the vehicle is not off, the memory position will not be recalled. 2-60