2010 Chevrolet Silverado 1500 Crew Cab Owner's Manual - Page 217
2010 Chevrolet Silverado 1500 Crew Cab Manual
Page 217 highlights
To remove or install cargo tie-downs at the front of the bed, slide the corner cap towards the center of the bed to expose the rail notches. To remove the corner cap, pull either edge away from the rail. To remove the system, loosen the toggle bolts on each rail until they can be removed from the bed of the truck. To replace the system, place the toggle bolts and rails into their original locations and tighten them to a torque setting of 12.5 ft lbs (17 Y). If the system is removed to install a bed liner, make sure there is no bed liner material in the installation points. Notice: If cargo is tied down using the horizontal slots on the top of the pickup box, the box could be damaged. Using the horizontal slots on the top of the pickup box for tie-down locations may cause damage to the pickup box and would not be covered by the vehicle warranty. Only use the tie-down loops if the vehicle does not have the cargo management system. Sunroof On vehicle with a power sliding sunroof, the ignition needs to be turned to RUN, or the Retained Accessory Power (RAP) must be activated to open or close the sunroof. When RAP is active, the sunroof will work for 10 minutes after the ignition is turned off, or until the driver's door is opened. See Retained Accessory Power (RAP) on page 3‑23 for more information. Do not leave the sunroof open for long periods of time while the vehicle is not in use. Debris can collect in the tracks and damage the sunroof operation and plug the water draining system. Extended Cab If your vehicle is an extended cab, the sunroof switch is located on the headliner above the rearview mirror. 3-79