2013 Chevrolet Express 2500 Passenger Owner Manual - Page 271

Vehicle Care 10-23 Power Steering Fluid How to Check Power Steering Fluid To check the power steering fluid: 1. Turn the key off and let the engine compartment cool down. 2. Wipe the cap and the top of the reservoir clean. What to Use To determine what kind of fluid to use, see Recommended Fluids and Lubricants on page 11‑12. Always use the proper fluid. Failure to use the proper fluid can cause leaks and damage hoses and seals. The power steering fluid reservoir is in the engine compartment on the driver side of the vehicle. See Engine Compartment Overview on page 10‑6 for reservoir location. 3. Unscrew the cap and wipe the dipstick with a clean rag. 4. Replace the cap and completely tighten it. 5. Remove the cap again and look at the fluid level on the dipstick. The level should be at the COLD FILL mark. If necessary, add only enough fluid to bring the level up to the mark. To prevent contamination of brake fluid, never check or fill the power steering reservoir with the brake master cylinder cover off. Washer Fluid What to Use When the vehicle needs windshield washer fluid, be sure to read the manufacturer's instructions before use. If operating the vehicle in an area where the temperature may fall below freezing, use a fluid that has sufficient protection against freezing. When to Check Power Steering Fluid It is not necessary to regularly check power steering fluid unless there is a leak suspected in the system or an unusual noise is heard. A fluid loss in this system could indicate a problem. Have the system inspected and repaired.