2014 Chevrolet Corvette Owner Manual - Page 58

2-30 . Keys, Doors, and Windows Other features may be affected while operating the convertible top: . If the top had recently been cycled repeatedly or left in an intermediate state, it will be temporarily disabled. A DIC message displays. Normal operation will be restored within 10 minutes after the system has cooled. If the vehicle battery is low, the power top operation may be disabled. Try to start the vehicle. A DIC message displays. If the battery has recently been reconnected or if the vehicle has been jump started, the top may not operate until the power windows have been indexed. Complete the power window indexing procedure. See Power Windows on page 2-21. The trunk can only be opened with the key until the convertible top is completely opened or closed. Do not try to start the vehicle while opening the top with the RKE transmitter. A DIC message may display. Release both buttons and wait a few seconds before starting the vehicle normally. The passive door unlock feature may not operate properly while using the RKE transmitter to open the convertible top. The windows cannot close while the top is moving. display. Press and hold M to open/close the top until this message is cleared. See Convertible Top Messages on page 5-31. Partial Top Cycling If the convertible top operation is stopped before completion, the top will temporarily hold its position. If the ignition is in ACC/ ACCESSORY or ON/RUN/START, the top will be held for up to five minutes. If the vehicle is moving or OFF, the amount of time will vary from a few seconds to about a minute. Beeps and DIC messages will be displayed before the top will move. When this occurs, immediately finish the convertible top operation by pressing the button again until it completes. If the top cannot be secured, keep clear of the top components. In some conditions the top may move quickly. . . . . . See Convertible Top Messages on page 5-31. If the vehicle battery has been disconnected and reconnected, the fuses were pulled or replaced, or a jump start was performed, the TOP NOT SECURE message may