2014 Chevrolet Sonic Owner Manual - Page 123
2014 Chevrolet Sonic Manual
Page 123 highlights
Instruments and Controls DIC Menu Items Press MENU to view the DIC menus. Some items display in the upper display area, some in the lower display area, and others use both the upper and lower display areas. Use w x to scroll through the menu items. Not all items are available on every vehicle. The following is a list of all possible menu items: ... 5-23 change the displays on the cluster and DIC to the type of measurements you select. Language This menu is not available while the vehicle is moving. Press SET/CLR while the language display is active and move w x to change the language of the displays when LANG SET is displayed. You will have to select 1 or 2 for the language display. 1 is Alphabet and 2 is Arabic Numeral. Press SET/ CLR to confirm the setting. Tire Learn This menu is not available while the vehicle is moving. This display allows for matching of the TPMS sensors. See Tire Pressure Monitor System on page 10-49 and Tire Pressure Monitor Operation on page 10-50. Remaining Oil Life This menu is not available while the vehicle is moving. This display shows an estimate of the oil's remaining useful life. If 99 : % is displayed, that means 99% of the current oil life remains. When the remaining oil life is low, the Code 82 message will appear on the display. The oil should be changed as soon as possible. See Engine Oil on page 10-9. In addition to the engine oil life system monitoring the oil life, additional maintenance is recommended in the Maintenance Schedule. See Maintenance Schedule on page 11-2. Remember, the oil life display must be reset after each oil change. It will not reset itself. Also, be careful not to reset the oil life display accidentally at any time other than when the oil has just been changed. Units Language Tire Learn Remaining Oil Life Units This menu is not available while the vehicle is moving. Press SET/CLR while the unit display is active and move w x to change units when UNIT SET is displayed. Press SET/ CLR to confirm the setting. You will have to select 1, 2, or 3 for the unit display. 1 is Imperial units, 2 is US units, and 3 is metric units. This will