2005 Chrysler Sebring Owner Manual Convertible - Page 71
2005 Chrysler Sebring Manual
Page 71 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 71 Headlight Beam Select Switch Pull the turn signal lever towards you to switch the headlights to HIGH beam. Pull the turn signal lever a second time to switch the headlights to LOW beam. Flash to Pass You can signal another vehicle with your headlights by lightly pulling the turn signal lever toward the steering wheel. This will cause the headlights to turn on at high beam and remain on until the lever is released. Headlight Time Delay This feature provides the safety of headlight illumination for about 90 seconds when leaving your vehicle in an unlighted area. To activate the delay, turn off the ignition while the headlights are still on. Then turn off the headlights. The delay interval begins when the ignition is turned off. If the headlights are turned off before the ignition, they will go off in the normal manner. WINDSHIELD WIPERS AND WASHERS The wipers and washers are operated by a switch in the right side control lever. Turn the end of the control lever to select the desired wiper speed. 3 Windshield Wiper/Washer Control NOTE: Always remove any build-up of snow that prevents the windshield wiper blades from returning to the OFF position. If the windshield wiper switch is turned OFF and the blades cannot return to the OFF position, damage to the wiper motor may occur.