2007 Chrysler PT Cruiser Owner Manual - Page 226
2007 Chrysler PT Cruiser Manual
Page 226 highlights
226 UNDERSTANDING YOUR INSTRUMENT PANEL 21. Oil Pressure Light Shows low engine oil pressure. The light will come on and remain on when the ignition switch is turned from the OFF to the ON position, and the light will turn off after the engine is started. If the bulb does not come on during starting, have the system checked by an authorized dealer. If the light comes on and remains on while driving, stop the vehicle and shut off the engine. DO NOT OPERATE THE VEHICLE UNTIL THE CAUSE IS CORRECTED. The light does not show the quantity of oil in the engine. This can be determined using the procedure shown in Section 7. (See page 363 for more information.) 22. High Beam Indicator This light shows that the headlights are on high beam. Pull the turn signal lever toward the steering wheel to switch the headlights from high or low beam. 23. Electronic Vehicle Information Center Display-If Equipped When the appropriate conditions exist, this display shows the Electronic Vehicle Information Center (EVIC) messages. (See page 227 for more information.) 24. Odometer/Trip Odometer Reset Knob Press this button to change the display from odometer to either of the two trip odometer settings. Trip A or Trip B will appear when in the trip odometer mode. Push in and hold the button for two seconds to reset the trip odometer to 0 miles or kilometers. The odometer must be in trip mode to reset. 25. Electronic Vehicle Information Center (EVIC) Button-If Equipped Pushing this button will switch between the different EVIC functions. (See page 227 for more information.)