2014 Chrysler 300 Owner Manual SRT - Page 464

462 WHAT TO DO IN EMERGENCIES NOTE: If the Mode Select Knob (5) is on Air Mode and If the tire does not inflate to at least 26 psi (1.8 Bar) the pump is operating, air will dispense from the Air pressure within 15 minutes: Pump Hose (7) only, not the Sealant Hose (6). • The tire is too badly damaged. Do not attempt to drive the vehicle further. Call for assistance. If the sealant (white fluid) does flow through the Sealant Hose (6): NOTE: If the tire becomes over-inflated, press the Defla1. Continue to operate the pump until sealant is no tion Button to reduce the tire pressure to the recomlonger flowing through hose (typically takes 30 - 70 mended inflation pressure before continuing. seconds). As the sealant flows through the Sealant If the tire inflates to the recommended pressure or is at Hose (6), the Pressure Gauge (3) can read as high as 70 least 26 psi (1.8 Bar) pressure within 15 minutes: psi (5 Bar). The Pressure Gauge (3) will decrease quickly from approximately 70 psi (5 Bar) to the actual 1. Press the Power Button (4) to turn off the TIREFIT kit. tire pressure when the Sealant Bottle (1) is empty. 2. Remove the Speed Limit sticker from the top of the Sealant Bottle (1) and place the sticker on the instru2. The pump will start to inject air into the tire immediment panel. ately after the Sealant Bottle (1) is empty. Continue to operate the pump and inflate the tire to the pressure 3. Immediately disconnect the Sealant Hose (6) from the indicated on the tire pressure label on the driver-side valve stem, reinstall the cap on the fitting at the end of latch pillar (recommended pressure). Check the tire the hose, and place the TIREFIT kit in the vehicle storage pressure by looking at the Pressure Gauge (3). location. Quickly proceed to (D) "Drive Vehicle."