2007 Dodge Caliber Owner's Manual - Page 303
2007 Dodge Caliber Manual
Page 303 highlights
MAINTAINING YOUR VEHICLE 303 Power Transfer Unit (PTU) - AWD/4WD Models Only Lubricant Selection Use only manufacturers recommended fluid. Refer to Fluids, Lubricants and Genuine Parts for correct fluid type. Fluid Level Check Visually inspected the unit at each oil change for leakage. If leakage is detected, Check the fluid level by removing the fill plug. The fluid level should be maintained between the bottom of the fill hole to 1/8 inch (4 mm) below the fill hole. Add fluid, if necessary, to maintain the proper level. Frequency Of Fluid Change Refer to the "Maintenance Schedule located if section 8 of this manual for the correct change interval for your type of driving. Appearance Care And Protection From Corrosion Protection Of Body And Paint from Corrosion Vehicle body care requirements vary according to geographic locations and usage. Chemicals that make roads passable in snow and ice, and those that are sprayed on trees and road surfaces during other seasons, are highly corrosive to the metal in your vehicle. Outside parking, which exposes your vehicle to airborne contaminants, road surfaces on which the vehicle is operated, extreme hot or cold weather and other extreme conditions will have an adverse effect on paint, metal trim, and underbody protection. The following maintenance recommendations will enable you to obtain maximum benefit from the corrosion resistance built into your vehicle. What Causes Corrosion? Corrosion is the result of deterioration or removal of paint and protective coatings from your vehicle. The most common causes are: • Road salt, dirt and moisture accumulation. 7