2008 Dodge Charger Owner Manual - Page 48

48 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE be reactivated if the driver's seat belt is unbuckled for more than 10 seconds and the vehicle speed is greater than 5 mph (8 km/h). BeltAlert௡ Programming The Enhanced Warning System (BeltAlert௡) can be enabled or disabled by your authorized dealer or by performing the following steps: NOTE: DaimlerChrysler does not recommend deactivating the Enhanced Warning System (BeltAlert௡). 1. With all doors closed, and the ignition switch in any position except ON or START, buckle the driver's seat belt. 2. Turn the ignition switch to the ON position, but do not start the engine. Wait for the Seat Belt Reminder Light to turn off and then proceed to the next step. NOTE: You must perform the following steps within 60 seconds of turning the ignition switch to the ON position. 3. Within 60 seconds of turning the ignition switch to the ON position, unbuckle and then re-buckle the driver's seat belt at least three times within 10 seconds, ending with the seat belt buckled. NOTE: Watch for the Seat Belt Reminder Light to turn on while unbuckling the seat belt and turn off while re-buckling the seat belt. It may be necessary to retract the seat belt. 4. Turn the ignition switch to the LOCK position. A single chime will sound to signify that you have successfully completed the programming. The Enhanced Warning System (BeltAlert௡) can be reactivated by repeating this procedure. NOTE: When the Enhanced Warning System (BeltAlert௡) is deactivated, the Seat Belt Reminder Light will continue to illuminate as long as the driver's seat belt is unbuckled.