2008 Dodge Ram 3500 Pickup Owner Manual - Page 163
2008 Dodge Ram 3500 Pickup Manual
Page 163 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 161 7. Return to the vehicle and press the programmed HomeLink button twice (holding the button for 2 seconds each time). If the device is plugged in and activates, programming is complete. If the device does not activate, press the button a third time (for 2 seconds) to complete the training. If you are have any problems, or require assistance, please call toll-free 1-800-355-3515 or, on the Internet at www.HomeLink.com for information or assistance. To program the remaining two HomeLink buttons, repeat each step for each remaining button. DO NOT erase the channels. Gate Operator/Canadian Programming Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of transmission - which may not be long enough for HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to "time-out" in the same manner. It may be helpful to unplug the device during the cycling process, to prevent possible overheating of the garage door or gate motor. If you are having difficulties programming a garage door opener or a gate operator, replace "Programming HomeLink," Step 3, with the following: 3. Continue to press and hold the HomeLink button, while you press and release - every two seconds ("cycle"), your hand-held transmitter until HomeLink has successfully accepted the frequency signal. The indicator(s) will change from a slow flash, to a rapid flash when trained. If you unplugged the device for training, plug it back in at this time. 3