2004 Ford F350 Owner Guide 3rd Printing - Page 65

Driver Controls 2. Position the end of your hand-held transmitter 1-3 inches (2-8 cm) away from the HomeLink௡ button you wish to program (located on your visor) while keeping the red light in view. 3. Simultaneously press and hold both the HomeLink௡ and hand-held transmitter button. Do not release REC DEL PLAY the buttons until step 4 has been completed. Some entry gates and garage door openers may require you to replace step 3 with procedures noted in the "Gate Operator and Canadian Programming" in this section for Canadian residents. 4. The red light will flash slowly and then rapidly. Release both buttons when the red light flashes rapidly. (The rapid flashing light indicates acceptance of the hand-held transmitters' radio frequency signals.) 5. Press and hold the just-trained HomeLink௡ button and observe the red light. If the light is a constant red, programming is complete and your device should activate when the HomeLink௡ button is pressed and released. Note: To program the remaining two HomeLink௡ buttons, begin with step 2 in the "Programming" section - do not repeat step 1. Note: If the red light blinks rapidly for two seconds and then turns to a continuous red, proceed with steps 6 through 8 to complete programming of a rolling code equipped device. 6. At the garage door opener receiver (motor-head unit) in the garage, locate the "learn" or "smart" button (usually near where the hanging antenna wire is attached to the unit). 7. Press and release the "learn" or "smart" button. (The name and color of the button may vary by manufacturer.) Note: There are 30 seconds in which to initiate step eight. 8. Return to the vehicle and firmly press, hold for two seconds and release the HomeLink௡ button. Repeat the press/hold/release sequence again, and, depending on the brand of the garage door opener (or other rolling code equipped device), repeat this sequence a third time to complete the programming. HomeLink௡ should now activate your rolling code equipped device. To program additional HomeLink௡ buttons begin with step 2 in the "Programming" section. For questions or comments, please contact HomeLink at www.homelink.com or 1-800-355-3515. 65 2004 F250/350/450/550 (f23) Owners Guide (post-2002-fmt) USA English (fus)