2005 Ford F150 Quick Reference Guide 1st Printing - Page 8

HEADLAMP AND PANEL DIMMER CONTROL Rotate the control clockwise one position from off to turn on the parking lamps. Rotate two positions from off to also turn on the headlamps. Rotate counterclockwise from off to activate autolamp (if equipped), which provides light-sensitive automatic on/off control of the exterior lights and keeps them on for a short period of time after the ignition is turned off. When the control is in any position except high beams or off, pull the control toward you to activate the foglamps (if equipped). 1 Use the panel dimmer control, located to the right of the headlamp control, to adjust the brightness of the instrument panel during the headlamps and parking lamps operation. Rotate to the full up position, past the detent, to turn on the interior lamps. Rotate to the full down position, past the detent, to prevent the interior lights from illuminating when doors are opened. POWER ADJUSTABLE PEDALS (if equipped) Press and hold the top end of rocker control to adjust the accelerator and brake pedal away from you. Hold the lower end of the control to move the pedals toward you. Adjust the pedals only when the vehicle is stopped and the gearshift lever is in the P (Park) position. 2 If equipped with memory function, the adjustable pedals, along with the driver's seat, can be automatically positioned in two programmable positions using the control located on the driver's seat. Refer to your Owner's Guide for instructions on how to use this memory feature. SERVICE ENGINE SOON LAMP Illuminates briefly when the ignition is turned to the ON position to ensure the system is functional. If the light comes on after the engine is started, refer to your Owner's Guide. This lamp will illuminate if the fuel cap is not fully secured. In addition, "Check fuel cap" will appear in the message center display. Make sure that the fuel cap is secure by turning it clockwise 1/4 of a turn until it stops. 3 ABS WARNING LAMP Illuminates briefly when the ignition is turned to the ON position. If the light comes on after the engine is started, refer to your Owner's Guide. 4 SPEED CONTROL (if equipped) To set the speed control, press the ON button and release. Accelerate to the desired speed and press the SET button and release. Once the system is engaged, an icon will appear in the instrument cluster. To increase speed, tap the SET button and the speed will increase in small increments each time, or use the accelerator pedal to reach desired speed and then press SET. To reduce speed, press and hold CST until desired speed is reached. Release or tap the CST button and speed will decrease in small increments. Also, you can depress the brake pedal until desired speed is reached and press SET. Press RES/RESUME to return the vehicle to a previously set speed if the vehicle is traveling more than 30 mph (48 km/h). 5 FOR REDUNDANT STEERING WHEEL CONTROLS (if equipped). To set the speed control, press the right side of the ON/OFF switch. Accelerate to the desired speed and press the right side of the CST/SET button and release. Once the system is engaged, an icon will appear in the instrument cluster.