2006 Ford F250 6.0 Liter Diesel Supplement 3rd Printing - Page 33

2006 Ford F250 Manual

Get 2006 Ford F250 PDF manuals and user guides View all 2006 Ford F250 manuals

Page 33 highlights

Maintenance and Specifications mounted on the driver-side of the vehicle next to the transmission case. On all vehicles, both filters should be replaced at the same time. The replacement filters are Motorcraft Part No. (FD-4604, F-Series) and (FD-4606, E-Series). FCM/HFCM drain procedure 1. Stop the vehicle and shut off the engine. The vehicle must be stopped with the engine off when draining the HFCM/FCM. Fuel may ignite if the separator is drained while the engine is running or vehicle is moving. 2. Locate the HFCM and place an appropriate container under the drain port (see illustration). • F-Super Duty • E-Series 3. Remove the drain plug, using a 6mm hex drive, by turning it counterclockwise. Allow the HFCM to drain for approximately 25 seconds or until clean fuel is observed. Install the drain plug by turning it clockwise until it is firmly seated. 4. Verify that the drain plug is closed and sealed, then remove the container from under the vehicle. 33 2006 Econoline (eco) Supplement USA (fus)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
mounted on the driver-side of the vehicle next to the transmission case.
On all vehicles,
both filters should be replaced at the same time. The
replacement filters are Motorcraft Part No. (FD-4604, F-Series) and
(FD-4606, E-Series).
FCM/HFCM drain procedure
1. Stop the vehicle and
shut off
the engine.
The vehicle must be stopped with the engine off when draining
the HFCM/FCM. Fuel may ignite if the separator is drained while
the engine is running or vehicle is moving.
2. Locate the HFCM and place an appropriate container under the drain
port (see illustration).
•
F-Super Duty
•
E-Series
3. Remove the drain plug, using a 6mm hex drive, by turning it
counterclockwise. Allow the HFCM to drain for approximately 25 seconds
or until clean fuel is observed. Install the drain plug by turning it
clockwise until it is firmly seated.
4. Verify that the drain plug is closed and sealed, then remove the
container from under the vehicle.
2006 Econoline
(eco)
Supplement
USA
(fus)
Maintenance and Specifications
33