2009 Ford Crown Victoria Severe Duty Supplement 1st Printing - Page 7

Severe duty equipment Taxi Pin 1 2 3 4 5 6 7 8 9 10 11 12 Function Not used Vehicle speed signal Battery saver 50A Battery Not used 50A Battery 20A Run/Acc 10A Run/Acc 50A Battery Not used 50A Battery 10A Run/Acc Gauge - 20 18 10 - 10 12 14 10 - 10 14 Color - Gray/Black Light green/Orange Light green - Tan/Yellow White/Pink Light Blue/White Yellow - Red/White Gray/White The mating connector is provided on the end of the Power Distribution Connector. The vehicle modifier can either purchase pins for the mating connector and install them on the wires before they are inserted into the connector, thereby avoiding any splicing, or purchase an optional power pigtail for the interface. The power pigtail (P/N 14A411) plugs into the Power Distribution Connector and provides blunt cut wires ready for splicing by the vehicle modifier. See the Police Interceptor Modifier Guide for more details. Rear Power Point - Police The Rear Power Point is a battery access port for Police auxiliary equipment mounted in the trunk. It is capable of supplying 80 amps of battery power. The Front Power Distribution Box (PDB) contains two fifty amp fuses, which protects the Power Point. Battery access is via two studs contained in an enclosure, mounted in the trunk, on the right side fender support. The terminal with the red wires is the battery positive, and the terminal with the black wire is the ground. Remove both fuses in the Front PDB before removing the cover to the rear power point. Ensure load devices can be turned off, and are switched off when reinserting fuses. 7