2010 Ford F350 Super Duty Crew Cab Diesel Supplement 1st Printing - Page 76

2010 Ford F350 Super Duty Crew Cab Manual

Page 76 highlights

Scheduled Maintenance: E-Series 150,000 miles (240,000 km) Change engine oil and replace oil filter Replace engine- and frame-mounted fuel filters Replace accessory drive belt(s) (if not replaced in the last 100,000 miles [160,000 km]) Replace front wheel bearing and wheel bearing grease seals (if non-sealed bearings) Change engine coolant (see Motorcraft Coolant Change Record) Change rear wheel drive (RWD) axle fluid - DANA axles not using synthetic fluid only Rotate tires, inspect tires for wear and measure tread depth and inspect wheel ends for endplay and noise (vehicles with dual rear wheels should only rotate if unusual wear is noted) Inspect air filter restriction gauge, replace filter as required Inspect and lubricate steering linkage, ball joints, suspension, tie rod ends, driveshaft and U-joints (lubricate if equipped with Zerk fittings) Check engine cooling system level, coolant strength (antifreeze & anti-corrosion) and hoses Inspect brake pads, shoes, rotors, drums, brake lines and hoses and parking brake system. Inspect exhaust system and heat shields Inspect automatic transmission fluid level Perform multi-point inspection (recommended) DEALER VALIDATION: RO#: DATE: P&A CODE: MILEAGE: 76 2010 Econoline (eco) Supplement (supplement), 1st Printing USA (fus)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104

150,000 miles (240,000 km)
Change engine oil and replace oil filter
Replace engine- and frame-mounted fuel filters
Replace accessory drive belt(s) (if not replaced in the last
100,000 miles [160,000 km])
Replace front wheel bearing and wheel bearing grease seals
(if non-sealed bearings)
Change engine coolant (see Motorcraft Coolant Change
Record)
Change rear wheel drive (RWD) axle fluid - DANA axles
not
using synthetic fluid only
Rotate tires, inspect tires for wear and measure tread depth
and inspect wheel ends for endplay and noise (vehicles with
dual rear wheels should only rotate if unusual wear is noted)
Inspect air filter restriction gauge, replace filter as required
Inspect and lubricate steering linkage, ball joints, suspension,
tie rod ends, driveshaft and U-joints (lubricate if equipped
with Zerk fittings)
Check engine cooling system level, coolant strength (anti-
freeze & anti-corrosion) and hoses
Inspect brake pads, shoes, rotors, drums, brake lines and
hoses and parking brake system.
Inspect exhaust system and heat shields
Inspect automatic transmission fluid level
Perform multi-point inspection (recommended)
D
EALER
V
ALIDATION
:
RO#:
P&A C
ODE
:
D
ATE
:
M
ILEAGE
:
Scheduled Maintenance: E-Series
76
2010 Econoline
(eco)
Supplement
(supplement)
, 1st Printing
USA
(fus)