2011 Ford F150 Regular Cab Quick Reference Guide 3rd Printing - Page 2
2011 Ford F150 Regular Cab Manual
Page 2 highlights
1 Headlamp Controls :T urns the headlamps off. Use extreme caution when using any device or feature that may take your attention off the road. Ford recommends against the use of any hand-held device while driving and that you comply with all applicable laws. Your primary responsibility is the safe operation of the vehicle. :T urns on parking, instrument panel, license plate and tail lamps. :T urns on low beam headlamps. :A utolamps (if equipped) Automatically turns the exterior lamps on/off based on available daylight. :T urns on fog lamps (if equipped) by pulling the control towards you. 4 Power adjustable pedals (if equipped) The accelerator and brake pedal should only be adjusted when the vehicle is stopped and the gearshift lever is in the P (Park) position. The control is located on the left side of the steering column. Press and hold the rear of the control to move the pedals toward you. Press and hold the front of the control to move the pedals away from you. 5 Airbag readiness light illuminates briefly when The airbag readiness light the ignition is turned on. If this light fails to illuminate, remains on or continues to flash after the engine is started, contact your authorized dealer as soon as possible. A chime will also sound if there is a malfunction in the indicator light. • To set a higher speed, press and hold SET + or press SET + repeatedly until the desired speed is reached. • To set a lower speed, press and hold SET - or press SET - repeatedly until the desired speed is reached. • To return to a previously set speed, press RSM. • To turn off, press the brake pedal or press OFF. VOL +/- : Press to increase/decrease volume levels. : Press to access the previous/next radio station, CD track or preset satellite radio channel. MEDIA: Press repeatedly to access all possible media sources. : Press to access voice recognition, if equipped. : Press to access SYNC® phone features, if equipped. Use the arrows and OK buttons on the left side of your steering wheel to scroll and make selections in these menus. Your main menu selections are: Gauge Mode, Trip A/B, Fuel Economy, Truck Apps, Settings and Information. • In the Truck Apps menu, you can select from Off Road and Trailer settings. • In the Settings menu, you can select from Driver Assist Features such as: Rear Park Aid, Rear View Camera, Trailer Brake and Trailer Sway Control. The vehicle menu provides access to features such as: Autolamp Delay, Compass, DTE (Distance to empty), Locks, Oil Life Reset, Running boards and Remote Start. You can also access the MyKey® menu and settings as well as adjust the language and more. For more information, refer to the Instrument Cluster chapter in your Owner's Guide. 11 E lectronic shift 4WD system (if equipped) Your vehicle may be equipped with an electronic shift 4WD system which allows you to choose between 2WD High, 4WD High or 4WD Low. Choose 2H (2WD High) to provide power to the rear wheels only - used mainly for street and highway driving. This mode provides optimal smoothness and fuel economy at high speeds. Choose 4H (4WD High) for extra traction on snow or on icy roads or off-road situations. (Not intended for dry pavement use.) Choose 4L (4WD Low) when you need extra gearing to provide maximum power to all four wheels at reduced speeds. This is intended for use in situations such as deep sand, steep grades or pulling heavy objects. The Electronic Locking Differential (ELD) (if equipped) is a device in the rear axle which allows both rear wheels to turn at the same speed which helps to provide additional traction if the vehicle becomes stuck. To activate, pull the knob toward you while the control is in either 4H (4x4 high) or 4L (4x4 low) mode. The indicator light will blink briefly and then remain solid. The indicator light will also display in the message center. AWD (if equipped) Depending on your option package, your vehicle may be equipped with AWD. With AWD, power is automatically delivered to all four wheels for increased traction. This mode is recommended for on-road driving conditions such as dry road surfaces, wet pavement, snow, gravel and shallow sand. becomes stuck in the snow, mud or sand, try turning off the AdvanceTrac® with RSC® system to allow wheel spin and help increase momentum to dig the vehicle out. The system defaults to on and the control will illuminate when turned off. Refer to your Owner's Guide for safety information and more details. 13 Se lectShift Automatic™ transmission Your SelectShift Automatic™ transmission allows you to manually change gears without using a clutch. This feature has two modes - PRS (Progressive Range Selection) and M (Manual) mode. • To use PRS, press - when the gearshift lever is in D (Drive). The available and selected gears will be indicated on the instrument cluster. Press - again to lock out gears beginning with the highest gear first. Press + to unlock gears to allow the transmission to shift to higher gears. Only the available gears will appear in the display and the transmission will automatically shift between those gears. • To use Manual mode, move the gearshift lever from D (Drive) into M (Manual). Press + to upshift or - to downshift. HD Radio Your navigation system also comes equipped with HD RadioTM technology. The system has a special receiver which allows it to receive digital broadcasts (where available) in addition to the analog broadcasts it already receives. Digital broadcasts provide a better sound quality than analog broadcasts with free, crystal clear audio and no static or distortion. For more information, refer to your Navigation supplement. 2 Panel dimmer control Use to adjust the level of brightness on the instrument panel during parking lamp and headlamp operation. Tap the left or right side of the control to brighten/dim the lighting, or press and hold until the desired level is reached. Blind spot mirror (if equipped, optional on the driver's side mirror only) The driver's side mirror may have a convex spotter mirror in the upper corner. This feature was designed to help you see a vehicle that may be in your blind spot. As a vehicle approaches, its image will transition from the large mirror to the smaller convex spotter mirror. 6 Anti-lock brake system (ABS) 3 M ulti-function lever and rain sensing wipers (if equipped) Rotate the end of the control up/down to increase/ decrease the speed of the wipers. Push the end of the stalk: • q uickly for a single swipe without fluid. • a nd hold briefly for three swipes with washer fluid. • a nd hold for a longer wash cycle. Courtesy wipe feature: One extra wipe will occur after a wash cycle to clear your windshield of any excess washer fluid. Rain sensing wipers (if equipped): These wipers activate automatically when moisture is detected on the windshield provided the multi-function lever is set to any setting other than OFF. The speed of the wipers will vary based on the amount of moisture on the windshield and also the interval setting. Ensure that the multi-function lever is turned to OFF prior to entering a car wash. Note: For optimal wiper performance, clean your blades and glass regularly. Refer to your Owner's Guide for more information. Turn signal operation: • T o operate the left turn signal, push the lever down until it stops and release. • T o operate the right turn signal, push the lever up until it stops and release. • T o indicate a lane change, push the lever up/down to the first stop position and release. The turn signals will flash three times and stop. warning lighT illuminates briefly when the ignition The ABS light is turned on. If the ABS light remains on or continues to flash, a malfunction has been detected, contact your authorized dealer as soon as possible. Normal braking (less ABS) is still functional unless the brake warning is also illuminated. light 5 9 3 1 2 4 6 7 8 9 10 11 12 13 16 15 14 14 Ambient lighting (if equipped) Press repeatedly to turn the feature on, cycle through your color options and turn the feature off. When activated, the foot well areas, cup holders and center console bin illuminates with the chosen color. Remote Start (if equipped) icon, you have remote start, If your IKT has the which allows you to start the engine from outside the vehicle. Note: Each button press must be done within 3 seconds of each other. If this sequence is not followed the vehicle will not remote start and the horn will not chirp. To use: to lock all doors. • Press • Then, press twice. • When you are ready to leave, insert the key into the ignition and turn to the on position before driving. • T o turn the engine off after using remote start, once. press 1 2 3 4 5 6 7 8 AUDIO Stereo In-Dash Six CD/MP3 satellite compatible sound system (if equipped) 7 Service engine soon light The service engine soon light illuminates briefly when the ignition is turned on. If it remains on or is blinking after the engine is started, the onboard diagnostics system (OBD-II) has detected a malfunction. Drive in a moderate fashion and contact your authorized dealer as soon as possible. 4 VOL (Power/Volume) Press to turn ON/OFF. Turn to increase/decrease volume. 5 AM/FM Press repeatedly to cycle through AM, FM1 and FM2 frequency bands. SEEK - Press to access the previous/next strong radio station, CD track or satellite radio channel (if equipped). 6 SIRIUS: Press SIRIUS repeatedly to cycle through SAT1, SAT2 and SAT3 modes (satellite radio, if equipped). Press MENU (when satellite radio is active) and then press to cycle through additional options. For a full description of these options, and SIRIUS® satellite radio, please refer to your Owner's Guide. 7 SOUND Press SOUND repeatedly to cycle through: Bass, Treble, Fade, Balance, and Speed Compensated Volume. When the desired selection appears in the display, press SEEK to make adjustments. 8 CLOCK Press CLOCK to set the time. The display will read SET TIME. Use the memory preset numbers (0-9) to enter the desired time- hours and minutes. The clock will then begin from that time. 8 Message center (if equipped) The message center monitors many vehicle systems and alerts you to potential vehicle problems and conditions. Your message center also allows you to program and configure certain features without taking your hands off the wheel. 9 Steering Wheel controls (if equipped) To set the speed: 1. P ress ON. 2. A ccelerate to the desired speed. 3. P ress SET + or SET - and take your foot off the accelerator. COCKPIT 10 Trailer Brake Controller (if equipped) The 2011 F-150 offers an available fully-integrated Trailer Brake Controller (TBC). TBC synchronizes vehicle and trailer brakes for seamless braking (even with the heaviest loads) to provide added driving control and confidence.* Factory-installed TBC with standard Trailer Sway Control (TSC) is a combination that's class-exclusive** to the 2011 F-150. *Remember, even advanced technology cannot overcome the laws of physics. It's always possible to lose control of a vehicle due to inappropriate driver input for the conditions. For more information about Ford vehicle stability systems, visit fordvehicles.com. **Class is Full-Size Pickups under 8,500 lbs. GVWR. 12 Trailer Sway Your vehicle is equipped with trailer sway control. This control uses the vehicle's AdvanceTrac® with RSC® system to detect and help reduce trailer sway by applying brake force at individual wheels and, if necessary, reducing engine power. If this happens, TRAILER SWAY REDUCE SPEED will display in the message center and the AdvanceTrac icon will flash briefly. For more information, please refer to your Owner's Guide. AdvanceTrac® with Roll Stability Control™ (RSC®) Stability Enhancement system The AdvanceTrac® with RSC® stability system helps you to maintain stability and steerability of your vehicle during a variety of road conditions. If your vehicle 15 Hazard flasher Press to activate the front and rear direction signals when your vehicle is disabled and is creating a safety hazard for other motorists. Press again to turn off. The hazard flashers will operate when the ignition is on or off. 16 VOICE-ACTIVATED NAVIGATION SYSTEM (if equipped) Your vehicle may be equipped with a voice-activated navigation system which integrates several functions including voice recognition, destination entry, climate control, and SIRIUS® satellite radio into one easy-to-use system, displaying them on an 8" touch screen display. Note: Some features are unavailable while driving. Refer to your navigation supplement for more information. 110V Power Point (if equipped) Located on the rear of the center console, this outlet is used for powering electrical devices which require up to 150W. Note: The 110V power point will turn off after 13 minutes if the ignition is in the on position without the engine running. Keep the engine running or cycle the ignition before the 13 minute time-out to keep the inverter on. 1 LOAD To load a CD into the system, press LOAD. When prompted, select the desired slot (1-6) using the memory presets and insert the CD into the system. Press and hold LOAD to autoload up to six discs. Insert the discs, one at a time, when prompted. To access other loaded CDs in the system: If you are already in CD mode, simply press the memory preset (1-6) which corresponds with the desired CD slot. If you are not already in CD mode, press CD and then press the desired memory preset (1-6). 2 DIRECT Press DIRECT and then, using the memory presets (0-9), enter in the numbers of the desired station, track, MP3 folder or satellite channel (if equipped). Memory Presets (0-9): You can save up to 30 radio stations (10 each in AM, FM1 or FM2) or 30 satellite radio channels, if equipped (10 each in SAT1, SAT2 or SAT3) in your memory presets. Tune to the desired station or channel and simply press and hold a memory preset (0-9) until sound returns. 3 SCAN Press for a brief sampling of radio stations, CD tracks or satellite radio channels (if equipped). Press again to stop.