2013 Ford Escape Warranty Supplement Printing 1 - Page 229

Maintenance 2.5L Engine 11. Reinstall the clean air tube assembly into the air cleaner assembly. 12. Tighten the air tube fastening screws. ADJUSTING THE HEADLAMPS Vertical Aim Adjustment The headlamps on your vehicle are properly aimed at the assembly plant. If your vehicle has been in an accident, the alignment of your headlamps should be checked by your authorized dealer. E142711 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. Loosen the screws on the air tube clamp that fasten it to the air filter assembly tray. Separate the clean air tube from the air cleaner. Remove the air cleaner from the vehicle. Loosen the screws that secure the air filter housing cover. Carefully separate the two halves of the air filter housing. Remove the air filter element from the air filter housing. Wipe the air filter housing and cover clean to remove any dirt or debris and to ensure good sealing. Slide the open end of the air filter element in first, below the tab. Then push the closed end cap into the bottom of the tray. The closed end cap should fit inside the groove in the tray. The tab at the end of the closed end cap should be oriented down and fit between the forks on the tray. Replace the air filter housing cover and secure the screws. Reinstall the air cleaner assembly into the vehicle. E142592 A B C D 8 feet (2.4 meters) Center height of lamp to ground 25 feet (7.6 meters) Horizontal reference line Vehicles With Halogen Headlamps 1. Park the vehicle directly in front of a wall or screen on a level surface, approximately 25 feet (7.6 meters) away. 2. Measure the height of the headlamp bulb center from the ground and mark an 8 foot (2.4 meter) horizontal reference line on the vertical wall or screen at this height. 229