2013 Ford Fusion Owner Manual Printing 3 - Page 47

Keys and Remote Controls 1. Insert the key blade into the slot on the bottom of the handle and press up. 2. While maintaining upward pressure, move the cap rearward to release it. Gently remove the key while doing so. To install the cap: Integrated Keyhead Transmitter The remote control uses one coin-type three-volt lithium battery CR2032 or equivalent. Press the button to release the key before beginning the procedure. E151957 E151798 1. Place the cap just forward of the key cylinder. 2. While applying pressure to the cap, move it forward until it is in place. You may hear a snap as it engages. Make sure the cap is properly installed by trying to move it rearward. 1. Insert a screwdriver in the position shown and gently push the clip. 2. Press the clip down to release the battery cover. Replacing the Battery Note: Refer to local regulations when disposing of transmitter batteries. Note: Do not wipe off any grease on the battery terminals or on the back surface of the circuit board. Note: Replacing the battery will not delete the transmitter from the vehicle. The transmitter should operate normally. A message will appear in the information display when the remote control battery is low. See Information Messages (page 91). E151799 3. Carefully remove the cover. 44 Fusion/Mondeo (CC7)