2015 Ford Transit Connect Passenger Owner Manual Printing 1 - Page 242
2015 Ford Transit Connect Passenger Manual
Page 242 highlights
Wheels and Tires Carrying Out the System Reset Procedure Read the entire procedure before carrying out a system reset. 1. Drive your vehicle above 20 mph (32 km/h) for at least two minutes and then park in a safe location where you can easily get to all four tires and have access to a tire inflation pump. 2. Switch the ignition off. 3. Switch the ignition on with the engine off. 4. Turn the hazard flashers on then off three times, this must be completed within 10 seconds. If the reset mode has been entered successfully, the horn will chirp once and the system indicator will flash. If this does not occur, repeat the procedure from step 2. If after repeated attempts to enter the reset mode, the horn does not chirp and the system indicator does not flash, have your vehicle checked by an authorized dealer as soon as possible. 5. Train the system sensors in the tires using the following reset sequence starting with the left front tire and following a clockwise order: Left front, right front, right rear, left rear. 6. Remove the valve cap from the valve stem on the left front tire. Decrease the air pressure until the horn chirps. Note: The single horn chirp confirms that the sensor identification code has been learned by your vehicle for this position. If a double horn chirp is heard, the reset procedure was unsuccessful and must be repeated. 7. Remove the valve cap from the valve stem on the right front tire. Decrease the air pressure until the horn chirps. 8. Remove the valve cap from the valve stem on the right rear tire. Decrease the air pressure until the horn chirps. 9. Remove the valve cap from the valve stem on the left rear tire. Decrease the air pressure until the horn chirps. Training is complete when the horn chirps after the last system sensor (left rear) has been trained and the system indicator stops flashing. 10. Switch the ignition off. If two short horn chirps are heard, the reset procedure was unsuccessful and must be repeated. Note: If after repeating the procedure two short horn chirps are heard again, have your vehicle checked by an authorized dealer as soon as possible. 11. Set all four tires to the correct pressure See Maintenance (page 185). or the tire inflation pressure label (located on the edge of driver door or the B-Pillar). CHANGING A ROAD WHEEL WARNINGS The use of tire sealants may damage your tire pressure monitoring system and should only be used in roadside emergencies. If you must use a sealant, the Ford Tire Mobility Kit sealant should be used. The tire pressure monitoring system sensor and valve stem on the wheel must be replaced by an authorized dealer after use of the sealant. If the tire pressure monitor sensor becomes damaged, it will no longer function. See Tire Pressure Monitoring System (page 235). Note: The tire pressure monitoring system indicator light will illuminate when the spare tire is in use. To restore the full function of the monitoring system, all road wheels equipped with tire pressure monitoring sensors must be mounted on the vehicle. 239 Transit Connect (CHC) Canada/United States of America, enUSA, First Printing