1996 GMC Sonoma Owner's Manual - Page 118

Finding a Station TUNE-AM-FM: Turn this knob to tune in radio stations. Press it to switch between AM and FM. SEEK: Press this button to go to the next higher station and stop. SCAN: Press this button to listen to each station fora few seconds. The radio willgo to the next station, stop for a few seconds, thengo to the next station. SCAN will appear on the display. Press SCAN again to stop scanning. PUSHBUTTONS: The four numbered pushbuttons let you return to your favorite stations. You can set up to 14 stations (seven AM and seven FM). 1. Tune in the desired station. 2. Press SET. In addition to the four stations set as above, up to three additional stations may be preset on each band by pressing two adjoining buttons at the same time. Just: I . Tune in the desired station. 2. Press SET. (SET will appear on the display.) 3. Press two adjoining pushbuttons at the same time, within five seconds. Whenever you press the same two buttons, the station you set will return. 4. Repeat these steps for each pair of buttons. Setting the Tone BASS: Slide this lever up to increase the bass. Adjust the lever until the sound is pleasing to your ear. TREBLE: Slide this lever up to increase the treble. You can reduce noise for weak or noisy stations by sliding this lever down. Adjusting the Speakers BAL: This control ring behind the PWR-VOL-PROG-RCL knob adjusts the balance between the left and right speakers. FADE: This control ring behind the TUNE-AM-FM knob the adjusts the balance between front and rear speakers. (SET appear on the display.) will 3. Press one of the four pushbuttons, within five seconds, to store the station. Whenever you press that numbered button, the station you set will return. 4. Repeat the steps for each pushbutton. 3-8