1997 GMC Sonoma Owner's Manual - Page 292

Using Foam-Type Cleaner on Fabric 1. Vacuum and brush the area to remove any loose dirt. 2. Always clean a whole trim panel or section. Mask surrounding trim along stitch or welt lines. 3. Mix Multi-Purpose Powdered Cleaner following the directions on the container label. 4. Use suds only and apply with a clean sponge. Don't saturate the material and don't rub it roughly. Using Solvent-Type Cleaner on Fabric First, see if you have to use solvent-type cleaner at all. Some spots and stains will clean off better with just water and mild soap. If you need to use a solvent: 1. Gently scrape excess soil from the trim material with a clean, dull knife or scraper. 2. Use very little cleaner, light pressure and clean cloths (preferably cheesecloth). Cleaning should start at the outside of the stain, "feathering" toward the center. 5. As soon as you've cleaned the section, use a sponge to remove the suds. 6 . Rinse the section with a clean, wet sponge. 7. Wipe off what's left with a slightly damp paper towel 3. Keep changing to a clean section of the cloth. 4. When you clean a stain from fabric, immediately the dry or cloth. 8. Dry it immediately with a blow dryer. 9. Wipe with aclean cloth. Fabric Protection Your vehicle has upholstery and carpet that has been treated with Scotchgard" Fabric Protector, a 3M product. It protects fabrics by repelling oil and water, which are the carriers of most stains. Even with this protection, you still need to clean your upholstery and carpet often to keep it looking new. Further information on cleaning is available by calling 1-800-433-3296 (in Minnesota, 1-800-642-6167). 6-54